LIFETONE HLAC150 Quick Start Manual

QUICK START GUIDE
Thank you for purchasing the Lifetone HL Bedside Fire Alarm and Clock. These items are included:
WARNING! DO NOT COVER
AC POWER
HLAC150
PLACE THE LIFETONE HL™ NEXT TO YOUR BED WITH THE SPEAKER FACING THE PILLOW.
STEP 1
- POWERING THE HLAC150™
1. Remove the battery door located on the back of your clock.
2. Insert four D cell alkaline batteries, as shown in the illustration at right,
matching the polarity (+ and –) signs in the open compartment.
3. Replace the battery door securely.
4. Plug the Lifetone HLAC150™ into an electrical outlet near your bedside.
5. You may plug the bed shaker in on the back of the clock now
or at any time after it has been set up.
The word "TEST" will now be ashing on the screen. Go to STEP 2.
NOTE:
The batteries are for backup in the event of a power outage only. The HLAC150 is not meant to operate on batteries alone.
STEP 2
- SMOKE ALARM COMPATIBILITY
This important test will determine if your smoke alarms are compatible with the Lifetone HL™.
1. The word "TEST" is ashing on the screen. Press the red TEST/SILENCE button on
the back of the clock. The word "TEST" will stop ashing for 30 to 50 seconds.
2. When "TEST" starts ashing again, locate the most distant smoke alarm you want detected.
3. Press and hold the test button on the smoke alarm until the Lifetone HL™
alarm sounds. Between 2 and 6 smoke alarm T3 cycles (groups of 3 beeps)
will be required. This takes about 10 to 30 seconds.
4. When the Lifetone HL™ alarm sounds and " F I R E " appears on the screen,
the test has been successful.
5. To stop the alarm, press the red TEST/SILENCE button on the back of the clock.
6. If all tests are passed, the "12 hr" time display option will ash on the
screen, and you may now set the clock. Go to STEP 3.
NOTE: If the clock is ashing all segments as shown below and beeping at
short intervals, your smoke alarm was not detected or is not compatible with
the LIFETONE HL™.
Unplug the clock and remove one battery. Repeat the set up beginning with
STEP 1- POWERING THE PRODUCT. You may need to choose a closer smoke alarm.
If the compatibility test fails again, the smoke alarm may not be compatible. Unplug
the clock and remove the batteries. See the section titled "UNSUCCESSFUL SMOKE
ALARM COMPATIBILITY TEST" in the user's manual.
– LIFETONE HL™ BEDSIDE FIRE ALARM AND CLOCK
™
Bed Shaker
BEEP!
KEEP THIS QUICK-START GUIDE IN A SAFE PLACE
MODEL HLAC150
4 D Cell Alkaline
Batteries
Install 4 D Cell
Alkaline Batteries
Press TEST/SILENCE
button to start the test.
Smoke alarm has been detected.
Press TEST/SILENCE
button to silence alarm.
HLAC150 User's Manual
TEST/SILENCE
BED SHAKER
Plug in Bed Shaker
TEST/SILENCE
BED SHAKER
T3 ALARM
SIGNAL
TEST/SILENCE
BED SHAKER
Successful test. You may
now set the clock.
Doc# LTQSG150 110831