LIFETONE HLAC151 Quick Start Manual

QUICK START GUIDE
Thank you for purchasing the Lifetone HL Bedside Fire Alarm and Clock. These items are included:
WARNING! DO NOT COVER
AC POWER
HLAC151
IMPORTANT: PLACE THE LIFETONE HL™ NEXT TO YOUR BED, WITH THE SPEAKER FACING YOUR PILLOW.
STEP 1
- POWERING THE HLAC151™
1. Remove the battery door from the back of your HLAC151™.
2. Insert four D-cell alkaline batteries as shown in the illustration at right,
matching the polarity signs (+ and –) in the open compartment. You
should do this before plugging your HLAC151 into a wall outlet.
3. Replace the battery door securely. A ashing "TEST" on the screen
tells you the batteries are installed correctly.
4. Plug the Lifetone HLAC151 into an electrical outlet near your bedside.
Don't use an outlet that is controlled by a wall switch.
5. You may plug in the bed shaker now or at any time after setup.
6. The word "TEST" continues to ash on the screen. Go to STEP 2.
NOTE: The HLAC151 operates on AC power. The batteries are only for backup during electrical outages.
STEP 2
- SETUP WITH YOUR SMOKE DETECTOR
Read and follow all the printed intructions below. The voice prompts supplement these instructions.
1. The word "TEST" is ashing on the screen and your HLAC151™ says, "Press the red
button to begin." Press and release the red TEST/SILENCE button on the back.
2. "TEST" stops ashing and your HLAC151 says, "Please wait."
3. After about 30 seconds, "TEST" starts ashing again and your HLAC151 says, "At the tone, test your
smoke alarm." This means it's time to press the test button on your smoke alarm.
4. Go to the most distant smoke alarm you want detected. If your alarms are interconnected, use the
nearest one instead. Press and hold the test button on the smoke alarm until the Lifetone HL™
alarm sounds, indicating a successful setup test. Between two and six T3 cycles (groups of
3 beeps) of the smoke alarm will be required. You'll need to hold the smoke-alarm button
down for 10 to 30 seconds.
5. If the test is not successful, try again using a nearer smoke alarm. You may try as
many times as you like. Your HLAC151 will continue with this test until it is successful.
6. When the test is sucessful, the Lifetone HL™ alarm sounds and " F I R E " ashes on the screen.
IMPORTANT WARNING: If you have First Alert alarms with voice, see section
in the HLAC151 User's Manual.
INSTRUCTIONS,
7. When the setup test has nished, the "12 hr" option for the time display appears on the screen
and your HLAC151 says, "Now, set the clock." Go to STEP 3.
If the setup test has not been successful after several tries, the smoke alarm may not be
issuing a T3 signal. See the section titled "
™
LIFETONE HL BEDSIDE FIRE ALARM AND CLOCK
MODEL HLAC151 WITH EASY SETUP
™
4 D-Cell Alkaline
Bed Shaker
Batteries
TESTING THE LIFETONE HL
KEEP THIS QUICK-START GUIDE IN A SAFE PLACE
HLAC151 User's Manual
Remove the
battery door
Install 4 D-Cell
alkaline batteries
IV., OPERATING
™ " in the User's Manual.
SETUP
VIDEO
TEST/SILENCE
BED SHAKER
Plug in the bed shaker
Press the TEST/SILENCE
button to start the test.
TEST/SILENCE
BED SHAKER
T3 ALARM
SIGNAL
Smoke alarm has been detected.
Successful test. You may
now set the clock.
Doc# LTQSG151E131227