LIFETONE HLAC150 Quick Start Manual

QUICK START GUIDE
Thank you for purchasing the Lifetone HL Bedside Fire Alarm and Clock. These items are included:
WARNING! DO NOT COVER
AC POWER
HLAC150
PLACE THE LIFETONE HL™ NEXT TO YOUR BED WITH THE SPEAKER FACING THE PILLOW.
STEP 1
- POWERING THE HLAC150™
1. Remove the battery door located on the back of your clock.
2. Insert four D cell alkaline batteries, as shown in the illustration at right,
matching the polarity (+ and –) signs in the open compartment.
3. Replace the battery door securel
tells you the batteries are installed correctly.
4. Plug the Lifetone HLAC150™ into an electrical outlet near your bedside.
Do not use an outlet controlled by a wall switch.
5. You may plug the bed shaker in on the back of the clock now,
or at any time after it has been set up.
NOTE:
The batteries are for backup in the event of a power outage only. The HLAC150 is not meant to operate on batteries alone.
STEP 2
- SETUP WITH YOUR SMOKE DETECTOR
2.
If you have interconnected alarms, use the nearest one.
3. Press and hold the test button on the smoke alarm until the Lifetone HL™ alarm sounds.
Between 2 and 6 smoke alarm T3 cycles (groups of 3 beeps) will be required. This takes
about 10 to 30 seconds.
4. When the Lifetone HL™ alarm sounds and " F I R E " appears on the screen,
the test has been successful.
5. To stop the alarm, press the red TEST/SILENCE button on the back of the clock.
6. If all tests are passed, the "12 hr" time displa
may now set the clock. Go to STEP 3. Important warning! If you have First Alert
talking alarms, see section
NOTE:
short intervals, your smoke alarm was not detected or is not compatible with
the LIFETONE HL™.
Unplug the clock and remove one battery. Repeat the setup beginning with
STEP 1- POWERING THE PRODUCT. You may need to choose a closer smoke alarm.
If the setup test fails again, the smoke alarm may not be compatible. Unplug
the clock and remove the batteries. See the section titled "UNSUCCESSFUL SMOKE
ALARM SETUP TEST" in the user's manual.
LIFETONE HL
™
Bed Shaker
ocate the most distant smoke alarm you want detected.
IV. OPERATING INSTRUCTIONS
BEEP!
KEEP THIS QUICK-START GUIDE IN A SAFE PLACE
BEDSIDE FIRE ALARM AND CLOCK
™
MODEL HLAC150
4 D Cell Alkaline
HLAC150 User's Manual
Batteries
Install 4 D Cell
Alkaline Batteries
reen, and you
in the HLAC150 User's Manual.
at
SETUP
Remove battery
door
Plug In Bed Shaker
(optional equipment,
not in all boxes)
Press TEST/SILENCE
button to start the test.
T3 ALARM
SIGNAL
Smoke alarm has been detected.
Press TEST/SILENCE
button to silence alarm.
Successful test. You may
now set the clock.
Doc# LTQSG150E130713
VIDEO
TEST/SILENCE
BED SHAKER
TEST/SILENCE
BED SHAKER
TEST/SILENCE
BED SHAKER