Subscribe to Our Youtube Channel
Related Manuals for Wet Sounds HT-4
Summary of Contents for Wet Sounds HT-4
- Page 1 HT-4 600 Watt 4 Channel Class D amplifier OWNER’S MANUAL ---------------------------------------------------------------------------------------------Wet Sounds HT-4 Owner’s Manual...
-
Page 2: Installation Instructions
Make sure your boats charging system is in good working order. Any high performance audio amplifier will increase the demand on your alternator and battery. If you are unsure have you charging system checked system testing by a professional technician. ---------------------------------------------------------------------------------------------Wet Sounds HT-4 Owner’s Manual... -
Page 3: Amplifier Connections
The HT-4 is designed for 4 AWG Power wire (+12 V) and Ground wire (GND). You will need to Power Connections prepare the wire by remove 5/8”... - Page 4 The HT-4 has both extended RCA inputs and outputs. (See below) Connect the RCA outputs from Amplifier Signal Inputs/Outputs the source unit into the inputs of the amplifier. The HT-4 has 2 pair of inputs, (Front & Rear), and is equipped with 1 pair of pass-through RCA outputs to connect to another amplifier.
- Page 5 **note if you only use the amplifier in 2 channel input mode you will not have fading capabilities between front and rear outputs.** The HT-4 utilizes removable speaker terminal blocks for easier installations and stronger power Speaker Terminal Inputs connections. The terminal blocks are designed to accept 12 AWG- 16 AWG speaker wire. When preparing the wire you will need to strip 5/8”...
- Page 6 9. Variable Crossover 3-4 – Built in 12db filter with crossover frequencies between 50Hz – 250Hz. 10. Bass Boost Control 3-4– This is a variable boost for the low frequencies to which the amplifier is set at on the crossover. ---------------------------------------------------------------------------------------------Wet Sounds HT-4 Owner’s Manual...
- Page 7 6. Ground—Connect this terminal directly back to the battery, using the shortest wire necessary to make this connection. Always use wire of the same gauge or larger than the (+) 12 volt power wire. ---------------------------------------------------------------------------------------------Wet Sounds HT-4 Owner’s Manual...
-
Page 8: Setting Up The Amplifier
“High-Pass” Is designed to play only the frequencies above where the crossover is set at. “Low Pass” Is designed to play only the frequencies below where the crossover is set at. “Full Range” This turns off the crossover and allows the amplifier to play every frequency. ---------------------------------------------------------------------------------------------Wet Sounds HT-4 Owner’s Manual... -
Page 9: Troubleshooting
B. Confirm that there are no loose wires that could be grounding out the amplifier. C. Check that the amplifier has sufficient air circulation where it is located. Insufficient air flow and overdriving the audio system could result in the amplifier going into protection to preserve the amplifier. ---------------------------------------------------------------------------------------------Wet Sounds HT-4 Owner’s Manual... - Page 10 Sample System Setups ---------------------------------------------------------------------------------------------Wet Sounds HT-4 Owner’s Manual...
- Page 11 ---------------------------------------------------------------------------------------------Wet Sounds HT-4 Owner’s Manual...
-
Page 12: Specifications
Specifications ---------------------------------------------------------------------------------------------Wet Sounds HT-4 Owner’s Manual... - Page 13 >95dBa >95dBa >95dBa Noise Ratio Idle Current 2.5 A 1.7A 1.4A 1.6A Rating Max Current Rating Crossover Switchable Switchable Switchable Low Pass Type Hi/Lo/Full Hi/Lo/Full Hi/Lo/Full Turn on Delay Operating 10V-16V 10V-16V 10V-16V 10V-16V Voltage ---------------------------------------------------------------------------------------------Wet Sounds HT-4 Owner’s Manual...
-
Page 14: Obtaining Service
Contact Wet Sounds directly at 1-877-938-7757 contact customer service to obtain RA # (Return Authorization). You are responsible for the shipping of the product to Wet Sounds. ---------------------------------------------------------------------------------------------Wet Sounds HT-4 Owner’s Manual...
Need help?
Do you have a question about the HT-4 and is the answer not in the manual?
Questions and answers