Wet Sounds HTX-5 Owner's Manual
  1. Manuals
  2. Brands
  3. Wet Sounds Manuals
  4. Amplifier
  5. HTX-5
  6. Owner's manual

Wet Sounds HTX-5 Owner's Manual

Hide thumbs

Advertisement

Table of Contents

HTX
SERIES
HTX-1, HTX-2, HTX-4,
HTX-6
O W N E R ' S M A N U A L
wetsounds.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HTX-5 and is the answer not in the manual?

Questions and answers

Related Manuals for Wet Sounds HTX-5

Summary of Contents for Wet Sounds HTX-5

  • Page 1 SERIES HTX-1, HTX-2, HTX-4, HTX-6 O W N E R ' S M A N U A L wetsounds.com...
  • Page 2 Wet Sounds™ products. WARNING We build all Wet Sounds products to play at high volumes for extended periods of time. Your ears however are not designed for high volume listening. This product can easily generate high volumes that can permanently damage your hearing.

  • Page 3: Installation Instructions

    If the amp can’t get all the power it needs it will not produce its full output. Your Wet Sounds amplifier will produce full output longer than other amplifies on the market today.

  • Page 4: Amplifier Connections

    Insert the +12 volt wire into the +12V side of the terminal block and then tighten the screw back into the terminal block. You will do the same for the Ground wire. See below Wet Sounds HTX Series Owner’s Manual...

  • Page 5: Remote Connection

    1 & 2 when in 2CH mode, or a separate set of RCA cables can be used in 6CH mode. **note if you only use the amplifier in 2 channel input mode you will not have fading capabilities between front and rear outputs.** Wet Sounds HTX Series Owner’s Manual...

  • Page 6: Power Indicator

    The amplifier is equipped with a dual illumination LED on the top of the amplifier that the Wet Sounds logo badge is mounted on. This amplifier is equipped with an advanced diagnostic system controlled by a microprocessor. In the event that the unit goes into protection for any reason it will flash a diagnostic code.
  • Page 7 11. Crossover Switch 5-6 - The HPF attenuates low frequencies and is used with mid-range speakers and tweeters. LPF attenuates high frequencies and is used for subwoofers. This controls channels 5 & 6. 12. Power LED Indicator and Logo Wet Sounds HTX Series Owner’s Manual...
  • Page 8 7. Speaker Terminal Output Block 3-4 – This is the speaker connecting block for channels 3 & 4. 8. Speaker Terminal Output Block 5-6 – This is the speaker connecting block for channels 5 & 6. Wet Sounds HTX Series Owner’s Manual...

  • Page 9: Setting Up The Amplifier

    SETTING UP THE AMPLIFIER Input Selection Because of the wide range of head unit/radio output configurations all Wet Sounds amplifiers have an adjustable input sensitivity or “GAIN”. The gain is NOT a volume or a power limiting control similar to a throttle. It makes the amplifier more sensitive to input from the stereo.

  • Page 10: Troubleshooting

    For HTX 4, 6 ampli ers, a short will only shut down the channels which are in fault. The other channels will contiunue to play. After a fault connection is cleared, the error code will continue to ash, while the logo is still illuminated blue. Please contact Tech Support for additional assistance, questions, etc. Wet Sounds HTX Series Owner’s Manual...

  • Page 11: Bridged Audio Rca Configuration

    HTX-4 Connection Panel Two dual male RCA Y-Splitters are required for this configuration. Please contact Wet Sounds Technical Support at 877.938.7757 if you need any assistance or how to bridge your HTX Series Amplifier. Wet Sounds HTX Series Owner’s Manual...
  • Page 12 SAMPLE SYSTEM SETUPS HTX-2 HTX-4 Wet Sounds HTX Series Owner’s Manual...
  • Page 13 HTX-6 HTX-6 Wet Sounds HTX Series Owner’s Manual...
  • Page 14 HTX-1 SPECS 9.527” 9.134” 8.346” Wet Sounds HTX Series Owner’s Manual...
  • Page 15 HTX-2 SPECS 9.527” 9.134” 8.346” Wet Sounds HTX Series Owner’s Manual...
  • Page 16 HTX-4 SPECS 9.527” 9.134” 8.346” HTX-4 4x100 4x150 2x300 Wet Sounds HTX Series Owner’s Manual...
  • Page 17 HTX-6 SPECS 13.23” 13.23” 12.83” 12.83” 12.05” 12.05” 6x100 6x150 3x300 Wet Sounds HTX Series Owner’s Manual...

  • Page 18: Limited Warranty

    LIMITED WARRANTY Length and limits of Warranty Wet Sounds warrants this product to be free of defects in material or workmanship for (1) year from the date of purchase. Wet Sounds warranty applies exclusively to the original purchaser, not transferable and the amplifier must be purchased from an Authorized Wet Sounds Retailer within the United States.
  • Page 19 WET SOUNDS INC. www.wetsounds.com 877-938-7757 10621 S Sam Houston PKWY W • Suite 100 Houston, Texas 77071 Wet Sounds HT-X Series Owner’s Manual...

This manual is also suitable for:

Htx-4Htx-2Htx-1

Table of Contents