Operation; Handle Position - Bissell 2012 3 series Owner's Manual

A
ssembly
Attach vacuum hose and tools continued
3. Snap the telescoping extension wand,
crevice tool, and combination tool into
storage clips as shown.
4. On board TurboBrush
The TurboBrush bracket slides onto the
hanger on the front of the handle. Attach
the bracket by aligning the slots with the
rectangular part on the hanger as shown
and pulling down until it is locked into place.
note: If you do not wish to store the Turbobrush
on your lift-Off vacuum, the bracket may be
hung on a wall for storage and the hanger may
be removed from the vacuum.
Place the TurboBrush in the bracket by aligning
the small holes near the brush roll with the
tabs at the bottom of the bracket and snap the
TurboBrush into place.
O
peration
Power switch/brush switch
The power switch is located just below the handle
on the front of the detachable canister. Push the
rocker switch "On" (I) to vacuum, and "Off" (O)
when cleaning is complete.
The brush switch is located just below the
handle on the front of the detachable canister
next to the power switch. This switch turns the
rotating brush on and off. The brush switch
should be in the "On" (I) position for normal
carpet cleaning. you may want to turn the brush
switch "Off" (O) for bare floor cleaning or other
delicate surfaces.
note: your bISSEll lift-Off Revolution
vacuum is equipped with a special internal
switch that turns the rotating brush off
whenever the unit is in the Upright position.

Handle position

1. Upright- For storage and above floor clean-
ing with special tools.
2. normal Cleaning- Press handle release
pedal once. Use for most household floor
cleaning tasks.
16 6
w w w . b i s s e l l . c o m w w w . b i s s e l l . c o m
(select models only)
®
3.
Crevice Tool
4.
TurboBrush
CAUTIOn:
before using your vacuum, make
sure that the Dirt Container and
Upper Tank are in locked position
and that all filters (Upper Tank,
Pre-Motor and Post-Motor) are
in place. Do not operate your
vacuum without these filters.
Tip:
Your vacuum features a Quick-Release
Cord Wrap. To remove the Power Cord
quickly and easily, rotate the Upper
Cord Wrap towards floor, and slip Power
Cord from Upper and Cord Wraps..
2.
Power
Combination
Tool
Telescoping
Wand
®
Brush
8 0 0 . 2 3 7 . 7 6 9 1 8 0 0 . 2 3 7 . 7 6 9 1