Operating Your Camera
SYNC : In areas where the supply is at 60Hz, you can
synchronize the output phase of multiple cameras
using the power synchronization function (Line-
Lock) without using a synchronization signal
generator.
- INT : Internal Synchronization Type
- L/L : Power Synchronization Type, Line-lock
• Press the Function Setup switch.
• You can select a desired phase from 0 to 359 when select 'phase'.
• You can decide the synchronization between luminance and color signal when
select the 'Mode' to TRACE.
Notes
• W hen using AC power at 60Hz frequency, you can use the L/L type synchronization.
• When the power is DC 12V, the SYNC menu is fixed to the 'INT' mode.
MOTION DET:
You can monitor activity more efficiently, because a
signal is generated by the camera whenever motion
is detected.
...... W hen the SPECIAL menu screen is displayed, press the Function Setup
❶
switch so that the arrow indicates 'MOTION DET'.
... Set up the mode using the Function Setup switch.
2
- SENSITIVITY : You can select up to 8 MD areas. When SENSITIVITY number is high,
motion detection sensitivity is increased to recognize even small
movement.
- AREA MODE : Determines whether to use the MD area selected in SENSITIVITY.
- SEL POS : Determines which of the 4 vertices of each MD area is to be used.
- YPOS : Determines the coordinate of the vertical axis for SEL POS.
- XPOS : Determines the coordinate of the horizontal axis for SEL POS.
- FILL → SET : Fills in a selected MD area. Fills in a selected MD area. The color of filling
is sequentially selected as brown, orange, blue, cyan, yellowish green,
yellow and red.
- RETURN : Select this to save the MOTION DET menu settings and return to the SPECIAL
menu.
26
COLOR DOME CAMERA
User's Manual
Notes
• M D areas show only MOTION DET menu. Therefore, MD areas don't display on the
monitor screen.
• W hen motion is detected, "MOTION DETECTION" expression is displayed on the screen.
PRIVACY : Hide an area you want to hide on the
screen.
...... ... When the SPECIAL menu screen is displayed,
❶
press the Function Setup switch so that the
arrow indicates 'PRIVACY'.
...... S et up the mode using the Function Setup
2
switch.
- AREA SEL : You can select up to 8 PRIVACY areas.
- AREA MODE : Determines whether to use the area
selected in the AREA SEL, the size
and position of the area.
- MASK COLOR : Determine area color. You can select Gray, Green, Red, Blue, Black,
White.
- TRANSP : Determine the transparency of the selected area adjust the level
between 0 and 3.
- RETURN : Select this to save the PRIVACY menu settings and return to the
SPECIAL menu.
DIS (Digital Image Stabilizer) :
This function mitigates any picture movement due to external factors such as
wind.
Notes
• I t is possible that the quality of resolution may decrease as the DIS function uses the digital
zoom.
• D IS doesn't operate when background illumination is too low.
• D IS doesn't operate when object pattern is monotonic as like sky or white wall.
• If DIS is enabled, the digital zoom is not configured to less than 46 level.
27
COLOR DOME CAMERA
User's Manual