Table of Contents
Advertisement
Resetting the system
Each time a tire inflation pressure has
been corrected or a wheel or tire has been
changed, reset the
system.<
Using the button in the center console
1.
Start the engine, but do not start driving.
2.
Press the button for approx. 4 seconds until
the warning lamp in the instrument cluster
lights up yellow. Warning lamp, refer to
Message for low tire inflation pressure on
page 82.
The message "Resetting TPM..." appears
on the Control Display for several seconds.
3.
Start to drive.
After driving a few minutes, the set inflation
pressures in the tires are accepted as the
target values to be monitored. The system
reset is completed during your drive, and
can be interrupted at any time. When driving
resumes, the reset is continued automati-
cally. The indicator lamp goes out after the
system reset is completed.
Via iDrive
For operating principle, refer to page 16.
1.
Press the
button
The start menu is called up.
2.
Press the controller to open the menu.
Online Edition for Part no. 01 41 0 014 699 - © 10/07 BMW AG
3.
Select "Settings" and press the controller.
4.
Select "Vehicle / Tires" and press the con-
troller.
5.
If necessary, move the highlight marker to
the uppermost field. Turn the controller
until "TPM" is selected and press the con-
troller.
6.
Start the engine, but do not start driving.
7.
Select "Reset" and press the controller.
8.
Select "Yes" and press the controller.
9.
Start to drive.
The tires are shown in gray and "Resetting
TPM..." is displayed.
After driving a few minutes, the set inflation
pressures in the tires are accepted as the target
values to be monitored. The system reset is
completed during your drive, and can be inter-
81
Advertisement
Table of Contents
