Schumacher Electric PID-760 Owner's Manual page 4

Connecting to a 12v Battery:
The PID-760 battery clamps allow quick hook-up to a 12V
battery. Make sure the PID-760 and the devices are turned
off.
1. Unscrew the positive (red) and negative (black) plastic
connector knobs from the back of the inverter.
2. Slip the end of the red (positive) battery cable clamp
wire over the red (positive) threaded extension and then
screw on the connector knob and tighten so the wire is
firmly attached. Repeat the same process for the black
wire.
. Connect the red (positive) battery cable to the positive
(+) battery terminal taking care to shield eyes, clothing
and hands from battery acid. Connect the black battery
clamp to negative (-) ground on the battery.
4. Plug the device into the Power Inverter 760 AC outlet.
NOTE: If using more than one device, the total combined
wattage of both devices must not exceed 760 watts.
5. Turn the inverter ON. To turn the inverter ON or OFF,
press and hold the button marked PRESS AND HOLD
FOR ON / OFF. The POWER OUT LED will glow and
the display will show 0.
OPERATING INSTRUCTIONS
4