Installing The Battery And Storage Card; Battery - HTC Touch Pro2 RHOD500 User Manual

18 Getting Started

1.3 Installing the Battery and Storage Card

You need to remove the back cover before you can install the battery and storage card. Also, make sure to
always turn off the power before installing or replacing the battery.
To remove the back cover
1. Make sure your device is turned off.
2. Remove the stylus.
Note You need to temporarily remove the stylus to be
3. Firmly hold the device with both hands and the
front panel facing down.
4.
Push the back cover up with your thumb until it
disengages from the device and then slide it up to
remove.

Battery

Your device comes with a rechargeable Lithium-ion battery and is designed to use only manufacturer-
specified original batteries and accessories. Battery performance depends on many factors, including network
configuration, signal strength, and usage patterns. For battery life estimates, see "Specifications" in the
Appendix.
Warning! To reduce risk of fire or burns:
To install the battery
1.
Align the battery's exposed copper contacts with the
battery connectors at the bottom part of the battery
compartment.
2. Insert the contacts side of the battery first and then
gently push the battery into place.
3.
Replace the back cover and insert the stylus back
into the stylus compartment.
To remove the battery
Lift out the battery from the groove at the upper right side of the battery compartment.
able to remove or replace the back cover.
•
Do not attempt to open, disassemble, or service the battery pack.
•
Do not crush, puncture, short external contacts, or dispose of in fire or water.
•
Do not expose to temperatures above 60˚C (140˚F).
•
Replace only with the battery pack designated for this product.
•
Recycle or dispose of used battery as stipulated by local regulations.
Groove