User Options - Amana LD510P Owner's Manual

User Options

Follow the instructions below to customized the
microwave oven's operation. End-of-cycle signal,
maximum heating time and other options can be
changed to meeting your cooking needs.
1. Open oven door.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 2 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
"OPTION".
3. Press number pad that matches desired option.
• "OP" represents optional program mode, first
number represents option number and second
number represents functions currently selected
for option.
Numbered Pads
1
End of Cycle Beep
2
Speaker Volume
3
Key Beep
4
Keyboard Enable
Window
5
Add Time during
Heating
6
Reset Door Open
7
Maximum Heating
Time
8
Manual Operation
9
Double Digit
Display Options ( ) = Factory Setting
OP:10 3 second continuous beep
OP:11 (Continuous Beep until door is opened)
OP:12 5 beeps bursts until door is opened
OP:20 Eliminates beep
OP:21 Sets volume to low; 60-70dB
OP:22 Sets volume to medium; 70-80dB
OP:23 (Sets volume to high; 80-90dB)
OP:30 Prevents signal when pad is pressed.
OP:31 (Allows signal when pad is pressed.)
OP:40 (30 seconds after oven door is opened, keyboard disabled)
OP:41 2 minutes after oven door is opened, keyboard disabled
OP:50 (Prevents adding heating time while oven is heating.)
Allows adding heating time while oven is heating.
OP:51
(Allows oven to resume heating time countdown after door is opened
OP:60
during cycle.)
OP:61
Cancels heating time count down after door is opened during cycle.
Allows 10 minutes of heating time.
OP:70
(Allows 60 minutes of heating time.)
OP:71
Allows use of preprogrammed pads only.
OP:80
(Allows use of manual time entry and preprogrammed pads.)
OP:81
OP:90
(Allows use of single digit only.)
Allows use of double digit only.
OP:91
4. Press START pad to advance to next option. See table
for options.
5. Press number pad (0,1-3) to change option.
6. Press START pad to save changes.
• Repeat steps 4-6 to change additional options.
7. Press STOP/RESET pad or close oven door to exit
programming mode.
Optional Program
Indicator
19
Pad Option
Number Selected