NAD T 758 Owner's Manual page 12

IDENTIFICATION OF CONTROLS
AVR 4 REMOTE CONTROL
12
11 VOL 5/6
• Increase or decrease loudness level. Release the button when desired level is reached.
•
The VFD on the front panel will indicate the level set. For NAD Receivers, the VFD will also show
"Volume Up" or "Volume Down" or "Volume: _ _ dB" (_ _ indicates the numerical dB level) while
pressing AVR 4's [VOL 5/6 ] buttons.
12 A/S/D/F, ENTER
Select an item in a menu.
13 SLEEP
Switch off the NAD Receiver or Tuner after a preset number of minutes.
SLEEP MODE
The Sleep Mode timer will switch the T 758 to Standby mode automatically after a preset number
of minutes. Pressing the AVR 4's [SLEEP] button once will display the current setting of the sleep
time mode or remaining time before the T 758 goes to standby mode. Pressing the AVR 4's [SLEEP]
button a second time within a 3-second period will change the sleep time mode to the next sleep
time setting. Each consecutive press increases the sleep time in 15-minute increments from 15 to
90 minutes. To cancel the sleep mode, continue pressing the AVR 4's [SLEEP] button until "Sleep
Off" is displayed on the VFD. Switching the T 758 to standby mode from either the AVR 4's OFF or
the T 758's Standby button will also cancel the sleep mode.
14 EQ
Enable or disable Equalization (EQ) effect as set up at Auto Calibration. This is not applicable to
T 758.
15 TONE
Adjust Treble or Bass level. Toggle [TONE] and then use [ D/F ] buttons to set up values.
16 L.NITE
Set Dynamic Range Control (DRC) level. Toggle [L.NITE] to select either DTS or Dolby DRC setting
and then use [ D/F ] buttons to set up DRC level. This is not applicable to T 758.
BD PLAYER CONTROL (use with compatible NAD Blu-ray Disc Player models)
Set the DEVICE SELECTOR to "BD" in order to gain access to these buttons. Some of the control buttons
below are applicable only to specific NAD Blu-ray Disc Players; check the owner's manual of your NAD
model for control button compatibility. You can also load the applicable NAD code library to this
device so that it can be made compatible with your other NAD equipment. Refer to the section below
about "LIBRARY" on how to load a NAD code library.
HOME: Display or exit HOME menu.
PICTURE: Display or exit the Picture Mode menu.
SCAN [5/6]: Fast reverse/forward search.
RES: Set output resolution of HDMI and Component Video output.
TITLE/POP-UP: Display DVD title menu or BD-ROM pop-up menu, if available.
MENU: Access disc menu, if available.
D/F/A/S: Select an item in a menu. Select desired track, chapter, file or folder. In some
applications, one has to press [ENTER] to complete the selection.
ENTER: Confirm selected option, item or menu.
DISP: Show playback time and other display information.
RTN: Exit from a menu window.
[k]: Open or close disc tray.
[g]: Stop playback.
[;]: Pause playback temporarily.
[9]: Go to the beginning of current or previous track, chapter or file.
[4]: Start playback.
[0]: Go to next track, chapter or file.
RAND: Play tracks/files in random order.
RPT: Repeat track, chapter, file or whole disc.
PROG: Enter or exit program mode.
CLEAR: Delete programmed track/file.
A,B,C,D: Navigate or select BD-ROM menu, if applicable.