NAD T 758 Owner's Manual page 10

IDENTIFICATION OF CONTROLS
REAR PANEL
14 AUDIO PRE-OUT
• The AUDIO PRE- OUT makes it possible to use the T 758 as a pre-
amplifier to external power amplifiers for some or all channels.
Connect FRONT L, FRONT R, CENTER, SURR R, SURR L, SURR-BL and
SURR-BR to the respective channel input of a power amplifier or
amplifiers driving the corresponding applicable speakers.
• Unlike the full range channels, there is no power amplifier built-into
the T 758 for a subwoofer. Connect the SUBW output to powered
("active") subwoofers or to power amplifier channels driving a
passive system.
ZONE 2
• SURR-BL and SURR-BR are also assigned as secondary ZONE 2 OUT.
This is applicable only if "Zone 2" is the selected setting of "Back
Amp" in the "Amplifier Setup" menu. For further information, refer
to the item about ZONE CONTROLS at the USING THE T 758 - MAIN
MENU segment of the OPERATION section.
• Refer also to the item about ZONE 2 AT AUDIO PRE-OUT SURROUND
BACK in the ZONE CONTROLS segment of the OPERATION - USING
THE T 758 - MAIN MENU section.
NOTE
Never connect both the external amplifier and T 758's speaker outputs to
the same set of speakers.
15 ZONE 2
• Send zone selected audio source to the corresponding audio input
of a separately located additional amplifier or receiver (not supplied)
that can power its matching set of speakers.
•
Use high quality patch cables to reduce noise pickup over long
distance runs.
16 COMPONENT VIDEO INPUT 1-3, COMPONENT VIDEO OUT
• Connect the Component Video Input to Component Video output
of compatible source components, typically a DVD player, BD
player, digital cable box or other applicable components. Connect
Component Video Out to the Component Video input of a
compatible video monitor/TV.
•
Be sure to observe consistency in connecting the Y/Pb/Pr jacks
to the corresponding sources/inputs. The routing of the three
component video input is fully configurable via the Source Setup
item of the Setup Menu OSD.
• The T 758's sets of component video input and output are fully
wideband and compatible with allowable HDTV formats.
17 SPEAKERS
• Connect the respective speaker's FRONT L, FRONT R, CENTER,
SURR R, SURR L, SURR-BACK L, and SURR-BACK R channels to their
corresponding loudspeakers. Make sure the "+" (red) terminal and
"-" (black) terminal are connected to the corresponding "+" and "-"
terminals of the loudspeaker. Use extra care to ensure that no stray
wires or strands cross between posts or terminals at either end.
•
SURR-BACK L and SURR-BACK R can be assigned as Zone 2 speaker
level output. This is applicable only if "Zone 2" is the selected setting
of "Back Amp" in the "Amplifier Setup" menu. For further information,
refer to the item about ZONE CONTROLS at the USING THE T 758 -
MAIN MENU segment of the OPERATION section.
10