Page 2
This manual please contact AE Technical Support at 800- is not binding. American Eagle reserves the 321-3741 or email at right to change, at any time, any or all of the service@americaneagleacc.com...
Carefully read the operators manual before starting the unit. Failure to adhere to the instructions could result in serious bodily injury or property damage. The SHD-138 Hydraulic Air Compressor will all hose connections are tight, both air and provide safe and dependable service if operated hydraulic.
145 psi Never use plastic pipe or improperly rated metal and the air pressure valve disengages the pipe. Improper piping materials can burst and intake valve hold-open mechanism to allow the cause injury or property damage. SHD-138 Manual...
4.) Be careful not to move the threaded cap (1). 3.) After pressure is set, tighten locknut (2). Be careful Differential Pressure Adjustment: Proceed with the not to move nut (3) following while the compressor is running. SHD-138 Manual...
The following table is a list of routine maintenance items, including service intervals. Service intervals are listed as hours, days, or weeks, whichever occurs first. American Eagle recommends that these service intervals be followed. Before performing any maintenance function “Lock Out” or “Tag Out”...
The electric speed control installation of the PTO. (American Eagle P/N C0873) is used on most gasoline engines. The electronic speed controls Compressor Assembly: are used only on Ford 6.0 and 7.3L diesel Prepare the mounting location of the engines.
Page 10
Note: The case drain line from the hydraulic motor is also routed to the oil reservoir. American Eagle recommends a sufficient sized reservoir be provided which includes the proper suction and return filters. The cooler on the compressor is designed and sized to cool the air compressor efficiently.
Page 11
Typical Hydraulic Circuit for Single Stage Pump with PN 30533 Multiple Components Typical Hydraulic Circuit for Tandum (Two Part) Pump with PN 30532 Multiple Components SHD-138 Manual...
Page 15
” , t e t ” , t e t ” e l f l f f l l a Connecting rod assembly (includes items 43, 44, 45 & 46) Z658 n i l a l f SHD-138 Manual...
Page 16
& e t i & Z656 Valve set with gaskets (items 60, 61, 62, 63, 64, & 66) e t i & Intake manifolds shown for Start-Stop units only. See page 26 for Head Unloader manifolds. SHD-138 Manual...
Clean or replace check valve. Dirty after cooler or intercooler tubing. Remove and clean. Compressor runs hot: Faulty compressor values. Clean or replace valves. Dirty intake muffler. Clean or replace. Low crankcase oil level. Add compressor oil as needed. SHD-138 Manual...
Page 19
Check valve leaking. Clean or replace. Chassis engine RPM Faulty pressure switch. Replace pressure switch. continue to operate at high speed when air receiver Pressure switch wiring. Wires place on pressure switch incorrectly or reaches maximum capacity: loose ground wire. SHD-138 Manual...
Warranty service will be performed by any American Eagle new equipment distributor, or by any American Eagle-recognized service center authorized to service the type of product involved, or by the American Eagle factory in the event of a direct sale. At the time of requesting warranty service, the owner must present evidence of date of delivery of the product.
Need help?
Do you have a question about the SHD-138 and is the answer not in the manual?
Questions and answers