Installation; Complete The Installation - Pelican Calcite Cartridge System Owner's Manual

Calcite Cartridge System

Installation

from
Reverse Osmosis
system
Figure 3
1. Shut off the main water supply.
2. Attach the Mounting Bracket to the wall using the supplied Phillips Head Screws.
3. Attach the Calcite Cartridge System to the Mounting Bracket using the supplied Phillips Head
Screws.
4. Tighten the Filter Housing using the supplied Filter Wrench (counter clockwise).
5. Insert the inlet water supply line tubing from the Reverse Osmosis system into the Push-In
Connector on the inlet side of the housing cover. You will hear a click when the tubing is properly
seated in the connector.
6. Insert the outlet water supply line tubing to the Drinking Water faucet into the Push-In Connector
on the outlet side of the housing cover.
Note: Do not over-tighten any of the fittings during installation. All fittings should be hand-tight.

Complete the Installation

1. Turn on the main water supply.
2. Check for leaks.
©
2011 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Mounting
Bracket
to
Drinking Water
faucet
-Rev B
Page 8
Top View
www. pelicanwater.com
(877) 849-1635