Indoor Installation - Takagi Flash Water Heater T-KD20 Installation Manual And Owner's Manual

INDOOR INSTALLATION

When installed indoors, the T-KD20 water
heater shall be located in an area to maintain
the following minimum clearances around the
unit:
Indoor Installation Service Clearances
Left side of heater
Front (Maintenance space)
Back of heater
Right side of heater
Top of heater
The diagram below details the required
clearances around the unit:
Wall Hanging Installation
For a wall mount installation, use TK-BK01
brackets to securely attach the T-KD20 to the
wall.
Locate the heater as desired, but follow all
applicable local codes, as well as the indoor or
outdoor clearances
installation.
Standing Installation
If the unit is to be installed standing on a
surface, adjust the legs so that the unit stands
securely and is level (legs can be adjusted up
to 1").
Do not install the unit standing directly on a
combustible surface.
combustible base.
Use the included L brackets to connect the unit
to a wall to ensure that it does not fall over.
These brackets will maintain the required 1"
clearance between the back of the unit and a
combustible surface.
6"
24"
1"
2"
12"
that apply to the
Use a 3" non-
- 6 -