HP Bermuda User Manual page 18

2. HARDWARE SETUP
10) Floppy Disk Drive Connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After connect-
ing the single end to the board, connect the two plugs on the other end to the
floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-
tion when using ribbon cables with pin 5 plugged).
BERMUDA Floppy Disk Drive Connector
11) Wake-On-LAN Connector (3-pin WOLCON)
This connector supports a LAN card with Wake-On-LAN output. The connec-
tor powers up the system when a wakeup packet or signal is received through
the LAN card.
IMPORTANT: This feature requires that the Wake-On-LAN or PCI Modem
feature is enabled in BIOS software setup and that your system has an ATX
power supply with at least 720mA +5V standby power.
BERMUDA Wake-On-LAN Connector
18
FLOPPY
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
PIN 1
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
WOL_CON
PME
Bermuda User's Manual
Ground
+5 Volt Standby