EnGenius SN-920 ULTRA User Manual page 6

* Caller ID Log
Unread messages: Closed Envelope
Read messages: Open Envelope
No information or no Caller ID Service:
No Envelope is Displayed.
* Two-digit Number Display
Tracks Caller ID log and Phone
Directory record location.
* Line or Base Indicator
Indicates the base that is active.
(Example: )
* Battery Strength
Number of bars is proportional to the
amount of battery time remaining.
5. Keypad
19 button face keypad.
Backlight option can be set to O F F,
ON, or 8 seconds time out.
6. Talk / Flash
Answer incoming phone or two-way
radio (intercom) call. Place an
outgoing phone call.
This button also acts as the flash
button for functions like call waiting
and toggling between calls.
~ 5~
7. Volume key
Located on side of handset: up / down buttons control volume.
8. 2-WAY/ INTERCOM
Used to place an intercom call to another handset or base.
9. Dialing Keypad
Used for dialing phone numbers and entering alphanumeric
information into Phone Directory.
10. Ringer (not shown)
Emits several sounds to indicate various events or alarms.
Single Beep Successful operation
Double Beep Failed operation or invalid key. Also, indicates
power on / off.
Periodic Short Single Beep (every two seconds):
Low battery warning.
Periodic Long Series of Beeps
Indicates a call on-hold.
Continuous Beep (2 seconds): Indicates out of range while
in talk mode.
11. Battery Pack Slot (on back of handset)
12. Headset Adapter Port (on bottom of handset)
13. Left Soft Key
14. Right Soft Key
15. Scrolling Keys
16. END
On / O ff for power and to end (hang-up) a call
17. Status LED
Blinking: Stand by
Solid: O n a call or the first 8 seconds after power on
~ 6~
(repeat every 30 seconds):
(not shown)