EnGenius SN-920 ULTRA User Manual page 23

* Handset registered to a base with same ID.
9. Press END to return to the handset
main menu.
NOTE 1: Upon successful registration, your handset will
display "Reg OK New ID =
NOTE 2: Your handset will automatically exit the
REGISTRATION mode after 30 seconds.
NOTE 3: You can register your handset to a maximum of 4
base units. The handset ID number in the middle
of the top line of the handset display will not
change after registering the first base unit
(known as the primary base unit).
SECURITY FUNCTION: A third option is available for
deregistering all the handsets at once and generating a
new base ID code (system registration reset). This option
can be selected by pressing " MENU
a new base number (1-4). Both the handset and base
must be in the registration mode. All handsets registered to
this base unit will no longer have access to this base
without being re-registered to this base again.
De-Registering a Handset from all Base Units
1. Press the RIGHT SOFT FUNCTION key to select
2. Press the " " key to select the REGISTER option. 6
3. Press the " " key to select 4
RESET HAND. The LCD will
display the following screen:
~ 39~
ID Conflict
Base X
"
", " ", " ", then enter 6 3
MENU .
Dereg from
all bases?
YES NO
4. Press the LEFT SOFT FUNCTION
key for " YES ."
5. Deregistration is successful.
The handset has now been de-registered
from all base units. The handset ID number
will be reset to "00" as seen in the middle
of the top LCD line.
De-Registering a Handset from a Single
Base Unit
1. Press and hold the VOLUME and PAGE buttons on the base
the handset is to be de-registered from until there is a beep.
2. Press the RIGHT SOFT FUNCTION key to select
3. Press the " " key to select the register option. 6
4. Press the " " key to select DEREGISTER. The LCD will read: 2
" Dereg from base X " when de-registration is complete.
Register a Second, Third or Fourth Base Unit
NOTE: A handset can be registered to a maximum of 4
base units. All base units that come from the factory are
registered as base unit 01.
NOTE: If there is more than one base unit and a handset
is to be registered to more than one base unit, the base
unit's identification number must be changed from factory
default number of "1" to either "2", "3", or "4".
1. Plug in the new base unit to AC power and place a fully
charged battery pack into the handset.
2. Verify base unit's power light is on and turn on the handset
power by pressing and holding the END key for 2 seconds.
~ 40~
Dereg from
all bases
MENU .