OWNERS MANUAL MODEL AS 2000 _________________ INSTALLATION INSTRUCTIONS _________________ AntennaTek, Inc. 425 S. Bowen #4 Phone 303-772-9591 Longmont, CO 80501 303-774-9533 www.antennatek.com...
Receiver Controller Coax out to TV Congratulations on your purchase of an AntennaTek Satellite System. There has been over ten years of engineering in this system. Please read through this entire manual, and the Receiver’s manual before beginning the installation. Should you have any questions, please call...
90 degree elbow where the wire mounting on solid roof. Contact coach manu- harness enters the coach. facturer to verify materials. AntennaTek, Inc. is not responsible for damage due to improper IV. GENERAL INSTALLATION INFORMATION installation of the satellite system.
dish mounting bracket is in the vertical position Pre- Marked area (90 degrees), press the Start button so Dish stops and remains in the vertical position to allow access to the base plate for mounting on the roof. Using (4) 1/4 x 3/8 screws and nuts attach the Dish to the mounting bracket.
Use a small screw driver to remove VII. CONNECTION OF THE ELECTRONIC COMPO- the first layer if it is still in position. NENTS With your finger, feel around for any wires that might be in the way and RECEIVER move them to the side. NOTE: The actual connection on the Receiver will NOTE: If roof is solid foam filled, use a differ between manufacturers.
“COAX - OUT TO TV” C. Connect the coax from the Receiver marked “TV OUT” to the “A” side of the Connecting this coax cable is the last step in this provided switch. installation. Read through this entire section before D.
Page 7
Satellite Receiver (Rear view) TV 1 Out to Satellite IN Antenna IN Splitter TV 2 Figure 8 5. If the Coach is equipped with an amplified antenna and is prewired for Satellite, connect an RG-6 cable from the connector marked satellite on the wall plate to the rear of the satellite receiver “Satellite IN”.
Page 8
C. Obtain Authorization to Return from the Company by the Company via an "Authorization to Return" form. and return the product to the Company: AntennaTek, Expedited shipment or shipment other than that of- Inc., 425 S. Bowen St., #4, Longmont, Colorado 80501.
Need help?
Do you have a question about the AS 2000 and is the answer not in the manual?
Questions and answers