SECTION I INSTALLATION INSTRUCTIONS This manual contains information on the following Signal Commander® 6000 models and accessories; the model you have purchased is clearly marked on the front of this manual. MODEL 150 Non-Amplified Antenna MODEL 250 Amplified Antenna MODEL 350 Amplified, 2nd TV Ready MODEL 500 Amplified, 2nd TV &...
1. installation Planning A. Pre-wired Vehicles closet can be used to mount the power supply. Follow the instructions in this manual in conjuction with the RV manufacture's recommendations to locate and Locating the antenna close to the television receiver install the Signal Commander Antenna and power and the 12 Volt DC power source will simplify the supply.
Page 4
Assure that the 12 Volt DC power source current is limited to 7.5A at 12Volt DC. Warning: Use of this power supply with any prod- uct other than AntennaTek Amplified RV antenna could result in fire or other damage. Crimp the quick disconnects onto the wires and push wires onto tabs on the circuit board (see power supply illustration for correct polarity).
Page 5
Install the arrow clip. Warning: Use of this power supply with any product other than AntennaTek amplified RV an- tenna could result in fire or other damage. Warning: Do not connect high current devices to 12 Volt receptacle.
SECTION II OPERATING INSTRUCTIONS 1. To Raise & Rotate Antenna 2. To Lower Antenna A : Rotate elevation handle clockwise. A clicking A: Pull rotation handle down to disengage gear from sound will occur when the antenna is completely ceiling plate and rotate the antenna until the pointer on extended.
Expedited shipment or shipment other than that of- C. Obtain Authorization to Return from the Company fered by the Company is available as an optional, and return the product to the Company: AntennaTek, customer paid service. Inc., P.O.Box 851, Longmont, Colorado 80502-0851.
This manual is also suitable for:
Signal commander 150Signal commander 250Signal commander 350
Need help?
Do you have a question about the Signal Commander 500 and is the answer not in the manual?
Questions and answers