Solving Problems; Cannot Connect To The Projector You Want To Use; Cannot Connect The Projector And The Computer Via Wireless Lan; Cannot Connect The Projector And The Computer Via Wired Lan - Epson EasyMP Multi PC Projection Operation Manual

Solving Problems

Cannot connect to the projector you want to use.

Cannot connect the projector and the computer via wireless LAN.

Check
Is the Wireless LAN unit connected?
Is the projector connection mode set to Quick connection mode? EasyMP Multi PC Projection cannot connect using Quick connection mode. Set the connection mode to Advanced
For wireless LAN connections, is the wireless LAN setting enabled
when the computer is in power save mode?
Are there any obstacles between the wireless LAN connection
access point and the computer or projector?
Is the computer's wireless LAN radio strength set to low?
Does the Wireless LAN conform to 802.11a, 802.11b, or 802.11g? It is only compatible with standards 802.11a, 802.11b, and 802.11g, and not with other standards such as 802.11.
Is Wireless LAN Power set to Off in the projector's Wireless LAN
menu?
Is the SSID setting different?
Is the same WEP key set?

Cannot connect the projector and the computer via wired LAN.

Check
Is the network cable connected correctly?
Are the computer's LAN card and the built-in LAN function
available?
Check that the Wireless LAN unit is securely connected.
connection mode.
User's Guide
s
Enable the Wireless LAN.
Sometimes the indoor environment prevents the projector from being found in a search. Check for any obstacles
between the access point and the computer or projector, and change their position to improve communication.
Set the radio strength to maximum.
Set Wireless LAN Power to On in the projector's Wireless LAN menu from the Configuration menu.
See the following manual for more details on the projector's wireless LAN settings.
User's Guide
s
Set the computer, the access point, and the projector to the same SSID.
When selecting WEP from Security, set the access point, the computer, and the projector to the same WEP key.
Check that the network cable is securely connected.
Check that LAN is valid by checking the device manager under Control Panel - System - Hardware.
Remedy
Remedy
32