Advertisement
10 为 off， [1---9] is based light address code settings (8421 binary code format),
DMX
control
are all OFF, the address is 001.
（receive）
Set to slave
All DIP dial to"OFF"
machine
Ⅵ、 Appendix
1、 Usage of the Signal Cable 、 Connector
The connection between the output and input, it's available to use the 3 pins
XLR cable which provided by the manufacturer. Signal cable from the DMX
output of the controller to the input of the first master light, an d connect to the
DMX input of second slave light from the DMX output of the first master light,
analogousl y， till connected all the slave lights, and insert the last connector to
the output of the final light.
If you want to prolong the connection of signa l cable, the connection of the pins
between male connector and female connector should be:1 to 1; 2 to 2; 3 to 3,or
it will cause communication interruption. （ Notice：the diameter of core of every
cable should be 0.5mm at least ， double core shelter cable shou ld be used ） .The
signal connecting must use the attached 3 pins XLR cable. Notice, all the
internal lead wire of the 3 pins XLR cable should not touch to each other or
connect to the connector.
The light is available to receive the DMX512 signal, connect t he signal plug to
the panel which marked with "IN" ， and connect it to the next light. then, connect
to the "IN" of next light from the "OUT". The DMX signal terminal organ is
recommended when the lighting signal is connecting. It will avoid to damage the
signal which caused by the noise, DMX terminal organ is a XLR connector,
connect with a 120Ω resistor between the pin 2 and pin 3 of the XLR connector, and connect
it to the last OUTPUT socket of the final light. Follow picture:
IN
OUT
IN
OUT
9
IN
OUT
Resi
stor
120R 1W
Advertisement
