Advertisement
Unscrew
ed the
6pcs
screws
on the
cover
First, after unscrewed the 6pcs screw on the cover and then pull out it. Then
unscrewed the 4pcs screw on the LED board and pull out it, if found the LED is
broken, then take out them by thermostat electri c iron. Installation method is just
the opposite.
1: The light power supply must be disconnected when replacement
of the LED does not bright
2: you can repair the light before you must use a thermostat with
anti-static electri c iron, and wear anti -static rings
2. Power supply, wire Connection
Using a dedicated plug to connect the SCANDLIGHT DJ LED GE PARD and
power. LED GALAXY LIGHT should pay attention to whether the voltage and
frequency between signs and on the power suppl y are the same or not. Suggested
that each light has a separate power supply switch, this can be turned on or off at
random for each LED GALAXY LIGHT. LED GALAXY LIGHT selection of input
voltage and frequency parameters as follows:
Voltage
If the power cable is damaged, please contact the area agents or ask professional
to replace; please use the same specification cable when you replace the power
cable.
Tip: When connecting the power, ground wire must (yellow / gre en color wire)
safet y ground, electrical installation must compl y with all relevant standards.
3. Fixed installation of lighting (including light hook and safety rope how to
Warning
AC100V～ 240V
Frequency
5
Unscrewed
the 4pcs
fixed
screws on
the LED
board
60/50Hz
Advertisement
