Safety Precautions - Stanley HG80 Service Manual

SAFETY PRECAUTIONS

To avoid serious injury or death
Wear Eye
Read the Manual
Protection
Wear Ear
Wear Dust Mask
Protection
• The operator must start in a work area without bystanders. Flying debris can cause serious injury.
• Do not operate the tool unless thoroughly trained or under the supervision of an instructor. Establish a training program for
all operators to ensure safe operation.
• Always wear safety equipment such as goggles, ear and head protection, and safety shoes at all times when operating the
tool. Use gloves and aprons when necessary.
• The operator must be familiar with all prohibited work areas such as excessive slopes and dangerous terrain conditions.
• Do not inspect, clean or replace the grinding wheel while the hydraulic power source is connected. Do not inspect or clean
the tool while the hydraulic power source is connected. Accidental engagement of the tool can cause serious injury.
• Always connect hoses to the tool hose couplers before energizing the hydraulic power source. Be sure all hose connec-
tions are tight and are in good condition.
• Do not operate the tool at oil temperatures above 140°F/60°C. Operation at higher temperatures can cause higher than
normal temperatures at the tool which can result in operator discomfort.
• Do not operate the tool with the wheel guard removed.
• Do not operate a damaged, improperly adjusted, or incompletely assembled grinder.
• Never wear loose clothing that can get entangled in the working parts of the tool.
• Keep all parts of your body away from the rotating wheel. Long hair or loose clothing can become drawn into rotating
components.
• Keep the wheel off all surfaces when starting the grinder.
• Do not use a wheel that is cracked, chipped or otherwise damaged. Always inspect wheels for possible damage before
installation or use.
• Always use wheels that conform to the specifications given in the OPERATION section of this manual.
• Do not reverse grinding wheel rotation direction by changing fluid flow direction.
• Do not move the tool until the wheel has stopped rotating. Release the trigger if the power supply has been interrupted.
Tool operators and maintenance personnel must always comply with the safety
precautions given in this manual and on the stickers and tags attached to the tool and
hose.
These safety precautions are given for your safety. Review them carefully before
operating the tool and before performing general maintenance or repairs.
Supervising personnel should develop additional precautions relating to the specific
work area and local safety regulations. If so, place the added precautions in the
space provided on page 4.
The model HG80 Hydraulic Grinder will provide safe and dependable service if oper-
ated in accordance with the instructions given in this manual. Read and understand
this manual and any stickers and tags attached to the grinder and hose before
operation. Failure to do so could result in personal injury or equipment damage.
47351
5