Agri-Fab LBD48C Owner's Manual page 9

PIVOT SUPPORT
BRACKET
FIRST HOLE
IN CHANNEL
& SLOT IN
PIVOT SUPPORT
BRACKET SHOULD
BE ALIGNED
HAIRPIN
COTTER
PUSH THROUGH
TO LARGE LOOP
FIGURE 16
To assemble lift handle to blade, assure that holes in end
of channel assembly are aligned with clearance slots in
sides of pivot support bracket as shown in figure 16.
From the left side insert the end of the lift rod through the
holes in the channel assembly. Next, align the hole in the
lift rod bracket with the lift link which was assembled to
the pivot support bracket. Secure with a hairpin cotter
inserted up through the cross hole in the lift link pin all the
way to the loop end of the hair pin cotter. See figure 17.
Using the furnished grease packet, apply a light coating
of grease to the straight upper portion of the lift rod. Slide
lift handle tube onto the lift rod. See figure 17.
LIFT HANDLE TUBE
LIFT ROD
LONG PIN
(LIFT LINK)
FIGURE 17
1/2" WASHER
CHANNEL
PIVOT PIN
SMALLEST
CHANNEL
HOLE
ASSEMBLY
ALTERNATIVE
HAIRPIN DESIGN
(Right Hand Side View)
BRACKET
HAIRPIN COTTER
(Left Hand Side View)
To attach loose end of cable to handle assembly, pass
cable around outside and underneath handle assembly
as shown in figure 17. Mount one 5/16" jam nut approxi-
mately 3/4" onto threaded end of control cable. Insert
threaded end of cable up through cable mount ear on
handle assembly and secure with a second 5/16" jam
nut. Tighten. See figure 18.
NOTE: Some further adjustment may be required after
blade assembly is completed.
HANDLE ASS'Y
BALL
END
HANDLE
GRIP
FIGURE 18
Assemble grip assembly to handle assembly using one
5/16" x 1-1/2" hex bolt and one 5/16" hex lock nut. Do not
overtighten lock nut; grip assembly must pivot freely.
See figure 19.
Assemble ball end of cable to a cable end fitting as was
done previously to other end of cable. Secure cable end
fitting to handle assembly with a 1/4" hex lock nut. Do
not overtighten lock nut; cable fitting must pivot freely.
See figure 19.
1/4" WELD
5/16" x 1-1/2"
HEX BOLT
GRIP
ASSEMBLY
HANDLE ASSMEBLY
FIGURE 19
9
CABLE MOUNT EAR
5/16"
JAM NUTS
(Right Hand Side View)
CABLE END
BOLT
FITTING
1/4 " HEX
LOCK NUT
5/16" HEX
LOCK NUT
CABLE END
FITTING
(Right Hand Side View)
CABLE