Operation And Adjustments - Agri-Fab LBD48C Owner's Manual

Raise the blade to the transport position. (This will
require extra effort since the extension spring is not yet
attached.)
Attach the long end of the extension spring to the upper
hole in the pivot support bracket and the short end to the
center slot in the channel as shown in figure 20.
Attach the long end of the blade pivot rod down through
the blade pivot shaft and the short end of the blade pivot
rod to the lift handle tube. Secure both ends with a
hairpin cotter pushed through to loop end. See figure 20.
Use the two plastic ties to hold the cable securely to the
outside of the handle tube and away from the tractor to
avoid direct heat from the tractor muffler. See figure 20.
BLADE PIVOT ROD
HAIRPIN
COTTER
EXTENSION
SPRING
PIVOT ROD
CHANNEL ASS'Y
PIVOT SUPPORT BRACKET
FIGURE 20
LIFT HANDLE
PLASTIC
TUBE
TIES
HAIRPIN
COTTER
(Left Hand Side View)
10