Agri-Fab LBD48C Owner's Manual page 8

Assemble one 5/16 jam nut approximately 3/4" onto
threaded end of control cable. Assemble threaded cable
end through round hole in cable mount bracket and
secure with another 5/16 jam nut. Tighten. See figure
13.
NOTE: Some further adjustment may be required after
blade assembly is completed.
CABLE MOUNT
BRACKET
5/16" JAM NUT
CHANNEL ASSEMBLY
FIGURE 13
Assemble ball end of control cable up through hole in
cable end fitting and pull till ball slips inside curled edge
of fitting. Note: If ball wont slip under edge of curl it will
need to be inserted through open end of curl. See figure
14
Assemble 1/4" x 1-1/4" hex bolt down through the cable
end fitting, the 5/8" long spacer and the left hand hole in
the channel assembly. Secure with a 1/4" hex lock nut.
See figure 14. Tighten.
CABLE END
FITTING
1/4" HEX LOCK NUT
FIGURE 14
5/16" JAM NUT
(Left Hand Side View)
1/4" x 1-1/4"
HEX BOLT
SPACER
(23658)
CHANNEL
ASSEMBLY
HOLE
REAR
(Left Hand Side View)
NOTE: The other end of the control cable will be
attached in a later step.
Attach blade assembly to channel assembly by inserting
the blade pivot shaft from the left side (bend facing up)
through the notched holes in the blade and channel
assemblies. Secure with two 1/8" x 1-1/4" cotter pins
through two holes in pivot shaft. Spread ends of pins.
See figure 15.
Hook blade adjust spring over spring mount rod as
shown in figure 15. Remove plastic cap, and one 3/8"
hex nut from bolt assembled in spring. Adjust the re-
maining 3/8" hex nut down approximately 1" onto the bolt
threads. Assemble bolt up through the hole in top edge
of blade and hold in place with the 3/8" hex nut removed
earlier. Tighten 3/8" hex nut on top edge of blade down
against the bottom 3/8" hex nut. Replace plastic cap
over end of bolt threads. See figure 15.
1/8" x 1-1/4"
COTTER PIN
BLADE
PIVOT
SHAFT
BLADE
SHOE
CHANNEL
ASS'Y
SPRING
MOUNT ROD
FIGURE 15
Place the end of the channel assembly up inside the
pivot support bracket. Align the hole second from the
end in the channel assembly with the front hole in the
pivot support bracket and secure through from the left
side with the channel pivot pin, the 1/2" washer and one
hairpin cotter. The hairpin cotter should be pushed all the
way through to the loop end. See figure 16.
NOTE: All hairpin cotters on this snow blade should be
pushed through to their loop end.
8
(TOP)
PLASTIC
3/8" HEX NUT
3/8" HEX NUT
(BOTTOM)
BLADE ADJUST
SPRING
1/8" x 1-1/4"
COTTER PIN
(Right Hand Side View)
CAP
BLADE
ASS'Y