Pride Mobility Jazzy Select Traveller Owner's Manual page 25

V . C O M F O R T
Controller Position
You can move the controller in toward or out away from the
armrest, or change the position the controller for either left-
hand or right-hand use.
WARNING! Do not place the controller
and charger cables so that they can be
pinched in the seat frame or the power
base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See
figure 13.
3. Slide the controller into or out of the armrest to the de-
sired position.
To change the controller position:
1. Unplug the controller and charger connectors from the
power base.
2. Cut the wire tie(s) securing the controller and charger
cable s to the armrest.
3. Flip up the armrest and loosen the setscrew. See figure 13.
4. Slide the controller out of the armrest.
5. Loosen the setscrew in the other armrest.
6. Place the controller in the other armrest.
7. Tighten the setscrew to secure the controller.
8. Use a wire tie to secure the controller and charger cables
to the armrest.
9. Plug the controller and charger connectors into the
power base.
Armrest Width Adjustment
You can change each armrest's width independently of the other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 12.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Select Traveller
A D J U S T M E N T S
ARMREST
KNOBS
Figure 12. Armrest Width Adjustment
Figure 13. Armrest Angle and Height Adjustment
www.pridemobility.com
SETSCREW
JAM NUT
ARMREST
ANGLE
ADJUSTMENT
SCREW
ARMREST
HEIGHT
ADJUSTMENT
SETSCREWS
25