Kurzweil K2000 Service Manual page 41

Section 3
KURZASSM.OOC
12122192
3.0 DISASSEMBLY/ASSEMBLY INSTRUCTIONS
DISCONNECTED AND ALL STANDARD ANTI-STATIC ELECTRICITY PRCAUTION:
PRIOR TO OPENING THIS UNIT IT IS IMPERATIVE THAT POWER BE ECAUTIONS
BE EMPLOYED. ANY DEVIATION FROM PROFESSIONAL AND PROPER
TECHNIQUES CAN RESULT IN A VOIDED WARRANTY.
3.1
3.1.1
3.1.2
3.1.3
ENCLOSURE SHELL
It is necessary to open the shell in virtually all instances
involving service. This procedure is simple and should be easily
remembered.
Place K2000 upside down on clean, smooth, padded surface. CARE
MUST BE TAKEN TO POSITION THE UNIT SO AS TO PROTECT THE WHEELS
FROM DAMAGE! Using a #2 Phillips screwdriver, remove the six (6)
machine screws securing the bottom half of the shell to the top -
one in each corner and two near the center of the bottom.
Carefully lift the bottom half and place in a safe location until
reassembly.
Refer to figures 3.1.1 and 3.1.2 for layout details.
NOTE: You may find a higher comfort level in placing the keyboard
away from your body thereby locating the major assemblies closer.
To reassemble, simply reverse the procedure in 3.1.2 above.
\ TOP ENCLOSURE
~--r===~~==~
Figure 3.1.1 Enclosure opening detail
1