Kurzweil K2000 Service Manual page 16

SECTION 2
2.0
2.1
2.1.1
WARNING:
WARNING:
2.1.2
1.
2.
3.
4.
5.
6.
7.
SETUP1.PUB 12/21/92
SETUP AND OPERATIONAL CHECKOUT
VOLTAGE SELECTION
The K2000 is equipped with a voltage selector which allows
operation on single-phase AC of 100 Volts, 120 Volts, 220 Volts,
or 240 Volts. The selector is set at the factory for the AC
line voltage most commonly in the country of destination. The
setting can be checked by looking at the small panel just to the
left of the AC power connector - a white indicator pin is
visible in the hole next to the selected voltage.
Do not attempt to operate the K2000 on any AC voltage other than the one selected - extensive
damage to the unit
may
result!
CHANGING THE VOLTAGE SELECTOR MAY REQUIRE THE USE OF A
DIFFERENT LINE CORD OR ATTACHMENT PLUG, OR BOTH. TO REDUCE
THE RISK OF FIRE OR ELECTRIC SHOCK, REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL
To change the selected voltage:
Turn the unit off and remove the AC line cord from the AC power
connector.
Open the cover of the fuse/voltage select compartment using a
small blade screwdriver or similar tool.
Pull the voltage selector card straight out of the housing,
using the indicator pin (See Figure 2.1 below).
Orient selector card so the desired voltage is readable at the
bottom.
Orient the indicator pin to
point up when the desired
voltage is readable at the
bottom (See Figure 2.2 below) .
Insert the voltage selector
card into the housing with the
printed side of the card facing
towards the AC power connector,
and the edge marked with the
desired voltage first.
If changing from 100V or 120V
to 220V or 240V, or vice-versa,
change fuse(s) and fusing
arrangement as described under
"Fuses"
Figure
2.1 -
Voltage Selector Card Removal
8. Replace compartment cover.
Verify the indicator pin shows the desired voltage.
Figure
2.2 -
Voltage Selector Card Orientation
I