Continuous Hoop Attachment - Singer Quantum XL-6000 Workbook

Quantum XL-6000
®

Continuous Hoop Attachment

The Quantum XL-6000 comes with the Continuous Hoop Attachment. You
®
can create borders for garments and home decorator projects. Heirloom
insertions can be created at a fraction of the cost of purchased Swiss
insertions, by embroidering borders on organza or batiste. Make interesting
sashings and borders for quilts, in contrast colors or tone-on-tone. You can
even embroider borders on ribbon.
HOW THE CONTINUOUS HOOP WORKS
This hoop is amazingly simple to use! There are 6 Continuous Hoop
embroidery designs built into the Quantum XL-6000 that are capable of being
®
sewn only when using the Continuous Hoop Attachment. It even comes with a
SmartMedia design card (#5006) which has a large assortment of borders in
various styles such as floral, Celtic, southwest, lace, heirloom, and more that
are ready to embroider.
This accessory is for continuous border sewing when the machine is set up in
the embroidery mode. The sewing field is 50mm x 120mm, which is
approximately 2" x 4¾". There is an adjustable Edge Guide at the right of the
hoop which is used for keeping fabric aligned when moving to the next area to
be embroidered. At the end of each embroidered segment, the machine
stitches a "v"-shaped marking stitch. The hoop has a clamp which is simply
lifted up, and then the fabric is pulled toward the back of the machine. The
needle is placed into the point of the "V"-shaped stitch, keeping the right edge
of the fabric aligned with the Edge Guide. Put the clamp back down and begin
embroidering the next section of the design. It is that easy!
- 49 -