Table of Contents
Advertisement
Quick Links
POWER
IR
EMITTER
5V DC
800-322-8346 • 859-233-4599 • www.audioauthority.com
Digital Video Single Coax Extender
800-322-8346 • 859-233-4599 • www.audioauthority.com
Digital Video Single Coax Extender
Model 1341T
HDMI INPUT
User Manual
POWER
IR
HXE-11 Series
EMITTER
TX
5V DC
OUTPUT
Model 1341T
Models 1341T and 1341R
HDMI INPUT
POWER
TX
POWER
OUTPUT
5V DC
800-322-8346 • 859-233-4599 • www.audioauthority.com
Digital Video Single Coax Extender
POWER
IR
POWER
5V DC
PASS
INPUT
THROUGH
800-322-8346 • 859-233-4599 • www.audioauthority.com
Digital Video Single Coax Extender
Model 1341R
Model 1341R
IR
HDMI OUTPUT
HDMI OUTPUT
TX
PASS
INPUT
THROUGH
POWER
POWER
TX
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Audio Authority 1341T
Summary of Contents for Audio Authority 1341T
- Page 1 800-322-8346 • 859-233-4599 • www.audioauthority.com 800-322-8346 • 859-233-4599 • www.audioauthority.com Digital Video Single Coax Extender Digital Video Single Coax Extender Model 1341R Model 1341T Model 1341R Model 1341T Models 1341T and 1341R HDMI OUTPUT POWER HDMI INPUT POWER HDMI OUTPUT POWER HDMI INPUT...
- Page 2 2048 Mercer Road, Lexington, Kentucky 40511-1071 Phone: 859-233-4599 • Fax: 859-233-4510 Customer Toll-Free USA & Canada: 800-322-8346 www.audioauthority.com WARNINGS • Read these instructions before installing or using this product. • To reduce the risk of fire or electric shock, do not expose to rain or moisture. • This product must be installed by qualified personnel. • Do not open the cover—there are no user-serviceable parts inside. • Do not expose this unit to excessive heat. • Install only in dry, indoor locations. • Clean the unit only with a dry or slightly dampened soft cloth. LIABILITY STATEMENT Every effort has been made to ensure that this product is free of defects. Audio Authority cannot be held liable for the use of this hardware or any direct ® or indirect consequential damages arising from its use. It is the responsibility of the user of the hardware to check that it is suitable for his/her requirements and that it is installed correctly. All rights are reserved. No parts of this manual may be reproduced or transmitted by any form or means electronic or mechanical, including photocopying, recording or by any information storage or retrieval system without the written consent of the publisher. Audio Authority reserves the right to revise any of its hardware and software following its policy to modify and/or improve its products where necessary or desirable. Audio Authority and the Double-A Symbol are registered trademarks of Audio Authority Corp. Copyright April, 2010. HDMI, the HDMI Logo, and High-Definition Multimedia Interface are registered trademarks of HDMI Licensing LLC in the United States and other countries. All other third party trademarks and copyrights are recognized.
-
Page 3: Table Of Contents
User Manual 1341T and 1341R HDMI Signal Distribution System ® TABLE OF CONTENTS 1.0 INTRODUCTION ......4 3.0 SYSTEM DESIGN ......5 4.0 COAXIAL CABLE FABRICATION ... . .6... -
Page 4: Introduction
• Up to 200 ft. cable length using RG-6 with 1080p and lossless audio • HDMI version 1.3 and HDCP compliant 1.3 HDMI VERSION 1.3 FEATURES SUPPORTED • 1080p/60 and 1080p/24 video • 1080i and 720p video • Lossless bitstream audio (Dolby TrueHD, DTS-HD: Master Audio, Multichannel LPCM) • Lip sync compensation 2.0 CHECKING PACKAGE CONTENTS Before connecting the system, please make certain the following items are in the shipping cartons. Note: the 1341T and 1341R are sold separately. • 1341T Transmitter Note: Please retain the original packing material and invoice in case you need to return the unit. • (and/or) 1341R Receiver If you find any items are missing, contact Audio • Termination resistor plug Authority immediately. Have the model number and invoice available for reference when you call. • 5V DC power adapter(s) • User manual... -
Page 5: System Design
3.0 SYSTEM DESIGN Consider the following factors and basic precautions to ensure the best possible performance. • Do not use soldered BNC connectors or adapters. RG-6 cables MUST be terminated with either crimp-on or compression type BNC connectors. • Use high quality RG-6 coaxial cable. The HXE-11 can transmit HD video over a single coax cable using high quality RG-6 and terminating with good crimp-on BNC connectors. Low quality cable and RG-59 cable does not provide the bandwidth necessary for the HXE-11 system. • Do not use HD-DVD players. The HDCP keys in the 1341T do not support Legacy HD-DVD players and will not handshake or pass signals. • Source and TV connection cables. Use short, premium HDMI cables; low quality cables are often unreliable. Always use good strain relief methods or locking cables to prevent cables from becoming loose over time. • Interference from nearby electrical devices can have an adverse effect on signal quality. For example, older computer monitors often emit very high electromagnetic fields that can interfere with the performance of nearby video equipment. • Display devices. The perceived quality of the video image depends heavily upon the type and quality of the TVs or projectors used. High quality displays should be expected to produce a noticeably better image. 3.1 APPLICATIONS The 1341T and 1341R may be used in simple point-to-point applications or in multiple destination video distribution applications. -
Page 6: Coaxial Cable Fabrication
Daisy Chain Distribution Application SOURCE NOTE: AC POWER CONNECTIONS ARE NOT SHOWN. HDTV 1341T HDTV 1341R RG-6 HDTV 1341R RG-6 RECEIVER 1341R “LOOP OUT” RG-6 TERMINATE LAST LOOP OUT JACK 4.0 COAXIAL CABLE LENGTH AND FABRICATION Use high quality RG-6. Audio Authority tests using Commscope F660BV Brightwire yielded excellent results; use equivalent cable or better in all installations. Maximum cable length depends on total bandwidth (video resolution plus audio). Use the table below as a guide, but it is recommended to test the actual cable length with the target source and TV before installation. Cable 1080p + lossless audio 1080i + lossless audio 720p + lossless audio RG-6 Up to 200 ft. Up to 300 ft. Up to 300 ft. • Use only crimp on or compression type BNC terminations. -
Page 7: Installation
• Do not bend coaxial cables below the manufacturer’s recommended radius. 800-322-8346 • 859-233-4599 • www.audioauthority.com 800-322-8346 • 859-233-4599 • www.audioauthority.com Digital Video Single Coax Extender Digital Video Single Coax Extender • Do not route coax cable parallel to AC power lines. • Always use a termination resistor plug (included) at the last (vacant) receiver Model 1341R Model 1341T pass through jack. • Connect coaxial cables and HDMI cables first, then connect power supplies. • Use good strain relief methods on HDMI cables to prevent loose connections, and power system for final testing. CONNECT SOURCE POWER POWER... -
Page 8: Troubleshooting
• Intermittent signal dropout: RG-6 and/or HDMI cable is longer than rated distance for source signal bandwidth. Reduce cable length, reduce resolution, and/or reduce audio format to decrease the bandwidth required. • No surround sound (multi-channel audio): adjust the source for the desired audio format, and make certain the destination device is able to receive it. • No picture: perform the verifications below. • Check that the termination plug is correctly installed on the pass through jack on the last receiver in the chain. • Note: Legacy HD-DVD players are no longer supported in current HDCP keys and do not function with the HXE-11 system. • Use only high quality RG-6 cable with crimp or compression type BNC terminations. DO NOT use soldered BNC terminations or adapters. • Use a cable tester to make certain coaxial cables are terminated correctly and the BNC connectors are securely attached to the cable at both ends. Check for cable defects or damage, such as pinched cable on tight corners. • Check the HDMI cables at input and output connections to see if any of the connectors have become loose. Use good strain relief methods. • Check the power indicators on all units. If any are off, check AC outlets. • Connect the display device directly to the source using the HDMI cable from the 1341T end, then test with the 1341R connection cable. If an image is present under those circumstances then the display, the source, and the HDMI cables can be eliminated as the cause of the problem. • If the above methods do not produce a picture, test using a short, known good HDMI cable, and set up the source to output a resolution that the display can accept. If this test is successful, connect the HXE-11 System again, making sure the source resolution is the same as the test. Contact Audio Authority Technical Service at support@audioauthority.com, or call 800-322-8346 or 859-233-4599. -
Page 9: Specifications
7.0 SPECIFICATIONS DIGITAL AUDIO/VIDEO I/O 1341T Transmitter 1x via HDMI connector – HDMI input 1341R Receiver 1x via HDMI connector – HDMI output COAXIAL CONNECTIONS I/O 1341T Transmitter 1x via BNC connector – coaxial output 1341R Receiver 1x via BNC connector – coaxial input VIDEO PERFORMANCE Resolutions Supported 720p, 1080i, 1080p and multiple PC resolutions Maximum resolution 1080p (1920x1200, 1080p/60Hz) HDMI TMDS clock speed 225MHz HDMI Data bit rate 2.25Gbps Maximum cable length using 200 ft. (60m) with 1080p / lossless audio premium RG-6 coax 300 ft. (90m) with 1080i / lossless audio 300 ft. (90m) with 720p / lossless audio AUDIO PERFORMANCE Digital Audio Multi-channel, lossless audio formats ENVIRONMENTAL Operating Temperature 0° to +50° C (+32° to +122° F) Operating Humidity... -
Page 10: Limited Warranty
8.0 LIMITED WARRANTY If any consumer product from Audio Authority fails due to defects in materials ® or workmanship within one year from the date of the original sale to the end- user, Audio Authority guarantees that we will replace the defective product at no cost. Freight charges for the replacement unit will be paid by Audio Authority (ground service only). A copy of the invoice showing the item number and date of purchase (proof-of-purchase) must be submitted with the defective unit to constitute a valid in-warranty claim. Units that fail after the warranty period has expired may be returned to the factory for repair at a nominal charge, if not damaged beyond the point of repair. All freight charges for out-of-warranty returns for repair are the responsibility of the customer. Units returned for repair must have a Return Authorization Number assigned by the factory. This is a limited warranty and is not applicable for products which, in our opinion, have been damaged, altered, abused, misused, or improperly installed. Audio Authority makes no other warranties either expressed or implied, including limitation warranties as to merchantability or fitness for a particular purpose. Additionally, there are no allowances or credits available for service work or installation performed in the field by the end user. 8.1 WARRANTY SERVICE PROCEDURES If you suspect a product defect, contact Audio Authority’s Technical Service Department at 800-322-8346 or 859-233-4599 for assistance in verifying the problem. If a defect or potential defect is suspected, a replacement unit will be shipped immediately on a defect-exchange basis and a Return Authorization Number will be issued for the return of the defective product. Replacement units are sent out at the Manufacturer’s Suggested Retail Price which is debited to the Customer’s Credit Card at the time of shipment. Once we receive the defective unit back at the factory, it will be evaluated under the conditions of this warranty and if found to be in-warranty, a full credit will be issued to the Customer’s Credit Card. Return freight charges for the defective unit are the customer’s responsibility. Please contact our Technical Service Department for complete details concerning all in and out of warranty service matters. We appreciate your confidence in our products and services and will always strive to meet or exceed your needs. -
Page 11: Regulatory Compliance
9.0 REGULATORY COMPLIANCE The 1341T and 1341R comply with HDMI and HDCP rules and regulations. ® Power supplies included have been tested for compliance with UL, CUL, CE, PSE, and GS rules and guidelines. This product and its power supply are RoHS compliant. 10.0 CONTACT INFORMATION If you have questions or require assistance with this product in areas not covered by this manual, please contact Audio Authority using the information below. Audio Authority Technical Service 800-322-8346 M-F 8:30 AM to 5:00 PM, EST International: 859-233-4599 Fax: 859-233-4510 Send email to: support@audioauthority.com Audio Authority Corporation 2048 Mercer Road Lexington, Kentucky 40511-1071... - Page 12 2048 Mercer Road, Lexington, Kentucky 40511-1071 Phone: 859-233-4599 • Fax: 859-233-4510 Customer Toll-Free USA & Canada: 800-322-8346 www.audioauthority.com 752-612 12/10...
Need help?
Do you have a question about the 1341T and is the answer not in the manual?
Questions and answers