Volvo XC 70 Owner's Manual page 282

06 Infotainment
Cell phone voice control*
Voice output volume
Press MY CAR and go to
settings Voice output
MENU and turn TUNE to raise or lower the
volume. Press EXIT to save the change and
exit the menu.
Using voice commands
The driver initiates a voice command dialogue
by pressing the voice control button (see the
illustration on page 279).
When a dialogue has been initiated, com-
monly used commands will be shown in the
display. Grayed-out texts or texts in paren-
theses are not part of the spoken command.
Once you become familiar with the system,
you can speed up the command dialogue by
briefly pressing the voice control button to
06
skip prompts from the system.
Commands can be given in several ways.
For example, the command "Phone call con-
tact" can be spoken as:
•
"Phone > Call contact"—say "Phone,"
wait for a system response, and then
continue by saying "Call contact."
•
"Phone call contact"—give the entire
command at one time
*
280
Option/accessory, for more information, see Introduction.
The following is a list of features that can be
voice-controlled with a Bluetooth
Settings Voice
cell phone.
volume. Press OK/
Shortcuts
Shortcut commands for using the phone can
be found in the MY CAR menu system, under
Settings
command list
General commands
information on the menu system.
Dialing a number
The system understands the digits zero to
nine. These numbers can be spoken individu-
ally, in groups of several digits at a time, or
the entire number can be given at once.
Numbers above nine will not be recognized.
The following is an example of a voice com-
mand dialogue. The system's response may
vary depending on the situation.
The user initiates the dialogue by
saying:
Phone > dial number
or
Phone dial number
System response
Number please
®
-connected
Voice settings Voice
Phone commands
and
. See page 209 for more
User action
Begin saying the digits in the phone number.
If you say several digits and pause, the sys-
tem will repeat them and prompt you by say-
ing "Continue."
Continue saying the digits. When you have
finished, complete the command by saying
"Dial."
•
You can also change the number by
using the commands "Correction" (which
deletes the last group of digits spoken) or
"Delete" (which will erase the entire
phone number).
Dialing from a call list
The dialogue below enables you make a call
from one of your cell phone's call lists.
The user initiates the dialogue by
saying:
Phone > dial from call list
or
Phone dial from call list
Continue by responding to the system's
prompts.
Calling a contact
The dialogue below enables you to call the
pre-defined contacts in your cell phone. See
the phone's user's guide if necessary.