Volvo XC 70 Owner's Manual page 123

both the HomeLink and hand-held trans-
mitter buttons.
Proceed with "Programming" step 3 to com-
plete.
Using HomeLink
To operate, simply press and hold the pro-
grammed HomeLink button until the trained
device begins to operate (this may take sev-
eral seconds). Activation will now occur for
the trained device (i.e., garage door opener,
gate operator, security system, entry door
lock, home/office lighting, etc.). For conven-
ience, the hand-held transmitter of the device
may also be used at any time. In the event
that there are still programming difficulties or
questions, contact HomeLink at:
www.homelink.com or by phoning the hotline
at 1–800–355–3515.
NOTE
If the ignition is switched off, HomeLink
will function for 30 minutes after the driv-
er's door has been opened.
The term "IC:" before the certification/registration number only signifies that Industry Canada technical specifications were met.
2
Resetting HomeLink Buttons
Use the following procedure to reset (erase
programming) from the three HomeLink but-
tons (individual buttons cannot be reset but
can be "reprogrammed" as outlined in the fol-
lowing section):
1. Press and hold the two outer HomeLink
buttons until the indicator light begins to
flash.
2. Release both buttons.
> HomeLink is now in the training (or
learning) mode and can be pro-
grammed at any time beginning with
"Programming" - step 1.
Reprogramming a Single HomeLink
Button
To program a device to HomeLink using a
HomeLink button previously trained, follow
these steps:
1. Press and hold the desired HomeLink
button. DO NOT release the button.
2. The indicator light will begin to flash after
20 seconds. Without releasing the Home-
Link button, proceed with "Programming"
- step 1.
03 Your driving environment
HomeLink ® Wireless Control System*
For questions or comments, contact Home-
Link at: www.homelink.com or phone 1–800–
355–3515.
This device complies with FCC rules part 15
and Industry Canada (IC) RSS-210. Operation
is subject to the following two conditions: (1)
This device may not cause harmful interfer-
ence, and (2) This device must accept any
interference that may be received including
interference that may cause undesired opera-
tion.
NOTE
The transmitter has been tested and com-
plies with FCC and IC rules. Changes or
modifications not expressly approved by
the party responsible for compliance could
void the user's authority to operate the
2
device.
*
Option/accessory, for more information, see Introduction.
03
121