Maintenance And Care; When You're Done - Bissell Powerfresh User Manual

carpet Refresher Attachment
This accessory is recommended for the
refreshing of carpets. Once the steam mop is
cradled in the carpet refresher attachment, it
will easily glide over the carpet.
NotE: Always be sure a mop pad is in
place before placing in carpet refresher
attachment. only white mop pads should
be used with the carpet attachment. Do
not use carpet attachment on spots or
stains, or glide it over the same spot for
no longer than 20 seconds.
1. Place the swivel mop head, with mop pad
attached, in the carpet refresher attachment.
NotE: the powerfresh™ Steam mop rests
in the carpet refresher attachment and may
not stay attached to the swivel mop head.
It is meant to glide over the carpet.
2. Fill water tank with water. begin refresh-
ing your carpet or rug by depressing the
steam-on-Demand trigger while pushing the
PowerFresh™ steam Mop in a forward and
backward motion, releasing steam as you go.
3. When you have finished refreshing your
carpet or rug, unplug the steam mop and
remove from the carpet or rug.
NotE: move the powerfresh™ Steam mop
and carpet refresher attachment in a con-
tinuous motion until you are finished. this
product is not intended to be used as a
carpet cleaner, only a carpet refresher
or deodorizer. Never attempt to use the
powerfresh™ Steam mop on carpet without
the carpet refresher attachment in place. Do
Not leave the mop in a stationary position.
Exercise extreme care when using the Steam
Mop on timber flooring. Ensure the Steam mop is
thoroughly tested in an inconspicuous area prior to
mopping a large floor area. The Steam Mop generates hot steam,
so when depressing the trigger to apply steam, ensure the Steam
Mop is moving continuously. The trigger does not need to be
depressed at all times. Prolonged application of steam in one area
increases the risk of damage to the surface treatment on timber
floors. Check with your timber floor treatment application special-
ist prior to Steam Mop operation. Regular foot traffic and direct
sunlight will wear down timber floor surface treatment making it
more susceptible to extreme care when using the Steam Mop on
timber flooring.
Maintenance & Care

When you're done

1. Unplug power cable from electrical socket.
2. Carefully remove the mop pad using the
Quick Release™ tab from the mop head. The
mop pad and lower assembly may be hot.
Remove spring breeze Freshening Disc from
mop pad.
3. Any water remaining in the water tank
should be emptied prior to machine storage.
4. Mop pad can be machine washed in warm
water. Use only liquid detergents. Do not use
fabric softeners or bleach. For best results,
air dry.
5. Wrap power cable around quick
release cable wrap on back of PowerFresh™
steam Mop.
6. Wipe all surfaces of PowerFresh™ steam
Mop with a soft cloth. store upright in a
protected, dry area.
Never put descaling aromatic, alcoholic, or deter-
gent products into the steam cleaner, as this may
damage it or make it unsafe for use.
Tinted plates on foot may get hot while steam mop is in use.
Do not touch while hot.
Upright storage of the PowerFresh Steam Mop with a wet mop
pad may result in the formation of white marks on your floor. To
remove the white marks, clean area with vinegar.
7