Connect With Synology Diskstation - Synology DX513 User Manual

7 Insert the hard drive tray key into the hard drive tray lock, turn the key
clockwise (to the "I" position) to lock the handle of the hard drive tray, and
then remove the key.
8 Repeat the above steps to install all the other disks on your DX513.
Note: If you want to set up a RAID set, it is recommended that all installed hard
disks are of the same size to make the best use of hard disk capacity.

Connect with Synology DiskStation

1 Connect one end of the power cord to the power port of DX513, and the
other to the power outlet.
Power port
2 Connect the expansion cable to the expansion ports of DX513 and Synology
DiskStation. You can connect up to 2 expansion units by expansion ports to
DS1512+/DS1812+.
e S A e S A
T A T A
The side inscribed
with "eSATA"
should face up.
After the connection is complete, DX513 will be turned on or off automatically
when the connected DiskStation powers on or off.
10 Chapter 2: Set Up DX513
DX513
Expansion Port 1
DS1512+
Expansion Port 2