Basic Operations; Detaching The Front Panel; Attaching The Front Panel; Initial System Start-Up - Alpine CDM-7857RB Owner's Manual

Basic Operations

2
1

Detaching the Front Panel

1
Press the PWR (Power) button to turn off the
power.
2
Press the (Release) button at lower left corner
until the front panel pops out.
3
Grasp the left side of the front panel and pull it
out.
NOTES
• The front panel may become hot in normal usage
(especially the connector terminals), this is not
malfunction.
• To protect the front panel, place it in the supplied
carrying case.

Attaching the Front Panel

1
First, insert the right side of the front panel into
the main unit. Align the groove on the front panel
with the projection on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
2
NOTE
Before attaching the front panel, make sure that there is
no dirt or dust on the connector terminals and no
foreign object between the front panel and the main unit.
4
-EN
PWR / INTLZ MODE / LOUD
1 1
c
1
• Controlable with Remote Control (CDM-7857RB
only)
This unit can be controlled with an optional
Alpine remote control. For details, consult your
Alpine dealer.
• Connectable to Remote Control Interface Box

(CDM-7857RB only)

You can operate this unit from the vehicle's
control unit when an Alpine Remote Control
Interface Box (optional) is connected. For
details, contact your Alpine dealer.

Initial System Start-Up

1
When operating the unit for the first time after
installation or after the vehicle's battery has been
disconnected and reconnected, set the volume
level to its minimum, then remove the detachable
front panel.
There is a small hole behind the front panel.
Press the Reset switch mounted behind the
small hole with a ball-point pen or any other
pointed object.
1
Reset switch

Turning Power On and Off

1
Press the PWR (Power) button to turn on the
unit.
NOTE
The unit can be turned on by pressing any other button
except the eject c button.
The volume level gradually increases to the
previous level you were listening to before the unit
was turned off.
Press the PWR button again to turn off the unit.