Finishing - Mitsubishi Electric XD80U User Manual

Power Cable Connections and Switching the Power On/Off

Finishing

1
Switch off the power of the connected equip-
ment
2
Switch off the power of the projector
Press the STANDBY button.
STATUS STANDBY
The [Power Off] display appears.
When the level gauge reaches maximum, the projection screen
will go off (in about 5 seconds) and the projector will enter the
power-off operation.
Note:
* The operation can be cancelled by pressing a button other than the
STANDBY button.
* One more press of the STANDBY button will switch off the power.
The STANDBY indicator changes to blinking amber and lights a
steady amber after about 90 seconds (when the unit enters the
standby mode).
STATUS STANDBY STATUS
Blinking amber
Lit green (Approximately 90
3
Unplug the power cable
Check that the STANDBY indicator is lit in amber and then
unplug the power cable.
The STANDBY indicator will go off when the power cable is un-
plugged.
4
Turn the lens cover counterclockwise until it stops.
The lens cover will stop with a click.
1
Instant Shut Down
When the power cord is unplugged directly after the power is turned off, the internal power supply is used to keep the cooling
fan turning and cool the lamp, so the projector can be moved immediately.
• It may be more difficult to turn the lamp back on if it has been cooled with the power cord unplugged.
• Do not place the projector in a bag, etc., while the cooling fan is turning.
(button on main unit)
STANDBY STATUS STANDBY
Lit amber
Standby mode
seconds)
E-21
STANDBY
MENU
RGB ENTER
VIDEO CANCEL QUICK
Q
FREEZE MUTE LAMP MODE AUTO
1 2 3 4
ASPECT
Power Off
OK ?
2