Table of Contents
Advertisement
Connecting Personal Computers and Video Equipment
Connecting this unit with a personal computer permits presentation data to be projected as a large screen display at
conferences, lectures, and on other occasions. Furthermore, connecting this unit to a DVD player or other video equip-
ment source in combination with an audio/video amplifier and speaker system will allow you to enjoy convincing home
theater.
Connections with Personal Computer
Please check the following before making connections with the personal computer.
•
A suitable resolution for this projector is 1024
XGA).
Make changes to a displayable resolution at the personal computer side. Please check with "Table of Supported Frequency" on
Page E-61.
•
The setting method for the personal computer will differ depending on the specific model. Please read the personal computer
instruction manual or the on-line help information, or contact the manufacturer of your personal computer.
Connect the projector's RGB connector using the included RGB signal cable.
•
When making connections with the RGB connector of the projector, please make the connection via the supplied RGB signal
cable.
•
The projector has been set to "Auto" at the factory; however, if it does not project, please change the input setting to "RGB"
using the menu sequence of [Setup] → [Input Format] → [RGB].
See "Input Format" on Page E-49.
Note:
* Before making connections, check the power of the projector and the equipment to be connected is switched off.
* When projection will be with a notebook computer connected, knowledge will be required for the cable connection and notebook computer
startup procedure as well as the operation that follows startup. Please consult the instruction manual of your notebook computer or the on-
line help.
768 dots (XGA). The maximum displayable resolution is 1280
RGB signal cable (Supplied item)
E-14
1024 dots (S-
MONITOR OUT
Personal
computer
Advertisement
Chapters
Table of Contents
