Bindicator RS-485 Installation & Operation Manual page 17

VIII. TROUBLESHOOTING
For technical or service questions, please call the manufacturer Customer Support at 1-800-788-9242.
For detailed dimensional drawings, go to www.bindicator.com
SYMPTOM
RSSI LEDs not on
Red Indicator LED is not
on
Top and or middle
Indicator LEDs is not
flashing
WRL180213 Rev. B
POSSIBLE CAUSE
Radio(s) are not powered on
Protocol switches do not match
Antenna not connected
Not wired correctly
Both (all) radios may not be powered
on
Units are not communicating
CORRECTIVE ACTION
Make sure the Indicator LED is red; if not
check wiring
Check dip switches and change if needed
Tighten antenna and put in most direct line
of sight to other radio
Reference wiring diagrams and check
wiring
Make sure the Indicator LED is red; if not
check wiring on both (all) units.
Check all wiring
13
www.bindicator.com