Short description 1 ON/OFF 6 Track indication ; Button to fold out the QuickOut Switch the set on/off by turning the - side A or 1 is played handle knob. - side B or 2 is played (reverse ope- Only possible with QuickOut car radios. If “Cod”...
Page 4
> M•L rocker switch (Medium wave - A TREB (Treble) Long wave) To adjust trebles. Use this rocker switch to select either medium wave (MW) or long wave (LW) B BASS frequencies. To adjust basses. To switch between these wavebands simply press the rocker switch again.
Contents Short description ......14 Radio Section ....... 19 Selection of the Desired Waveband ..19 Important information ....17 Automatic Station Tuning ...... 19 What you need to know! ....... 17 Manual Tuning ........20 Traffic safety ......... 17 Adjusting the Station Seek Sensitivity ...
Only use the accessory and replacement Using the QuickOut handle you can easily longer be restarted. parts approved by Blaupunkt. pull your radio out of the installation compart- ment to take it along. The preset stations Note: remain stored for a longer time.
• Enter the code number given in the The radio must be connected to permanent - Press preset button 2 five times, Blaupunkt car radio passport and con- power. “500” appears in the display. firm: See example “Restart following In order to switch the code system on: - Press preset button 3 twice, “520”...
Amplifier Section Radio Section Adjusting trebles ON/OFF Selection of the Desired Wave- band turn button A. For switching the set on, • turn button 1 This radio allows you to choose between the • FM, MW and LW wavebands. Adjusting basses Your stereo is now ready for operation.
Adjusting the local mode sensiti- Tuning of Previous Station The stereo function is activated automatical- vity 2 down. The ly when you turn your set on. • Press rocker switch The set will automatically switch to mono if radio will automatically seek the previ- In regions with extremely high station densi- reception is poor.
Activating a Stored Station Note: For selecting a sampled station: Press the knob 1 once again. If you tune into a station which has already • If required, the memorized stations can be been stored on another memory bank, the The Scan function is off.
Tape Section Care Notes Inserting the Tape Fast Rewind Press the FR (Fast Rewind) button 7. • We recommend C-60 and C-90 type tapes If you wish to play a cassette tape: Once the tape has been completely for use in any automobile tape player; to •...
Appendix Technical Data Amplifier Output power: 4 x 4.5 W watts RMS acc. to DIN 45324/3.1 4 Ω Sensitivity: 0.9 µV at 26 dB signal-to-noise ratio Frequency response: 35 - 15 000 Hz (-3 dB) Tape Section Frequency response: 31.5 - 16 000 Hz (-3 dB) Modifications reserved!