Optional Songbird Feature; Replacing Remote Control Batteries - Code Alarm CA-550 Owner's Manual

Optional Songbird Feature

The optional songbird feature (Code Alarm part # SB1 and labor required) allows you to program songs
and tones to your system (i.e. Setting a different tone for Lock activation and unlock activation).
Turning Songbird On: Press and release the TRUNK icon button on the remote control, then press and hold
the LOCK icon button on the remote control within 2 seconds. The SB1 speaker will give notification that
Songbird has be turned ON.
Turning Songbird Off: Press and release the TRUNK icon button on the remote control, then press and
hold the UNLOCK icon button on the remote control within 2 seconds. The SB1 speaker will give notification
that Songbird has be turned OFF.
Setting Songbird Tones: Press and release the TRUNK icon button on the remote control, then press the
OPT button on the remote control within 2 seconds. Press the LOCK icon button on the remote control or
UNLOCK icon button on the remote control to scroll through the different tones.
While in this mode the TRUNK icon button on the remote control will change the length or version of the
tone.
Press the OPT button on the remote control to select the desired tone and exit programming.
Please see your sales associate for details on Song Bird or any other Code Alarm accessory.

Replacing Remote Control Batteries

The two (2) 3 volt lithium batteries (model CR2025) inside each remote control should last
approximately 1 year under normal use. When the batteries become weak you will notice the remote
control range (the distance from the vehicle the remote control will work) deteriorate and the small LED
on the remote control will dim. To replace the remote control batteries:
1. Using a small (#1) phillips screwdriver, remove the screw on the back of the remote control.
2. Gently unsnap the halves of the remote control apart.
3. Slide the 2 lithium batteries out of the circuit board, observing the +/- symbols on the batteries
and replace with new lithium 3 volt batteries (model CR2025).
4. Gently snap the halves of the remote control back together and reinstall the phillips screw on
the back of the remote control.
5. Test operation of the remote control.
8