Download Print this page

Wiring Diagram - GEM DG-30 Operation User's Manual

Digital keypad / proximity entry system

Advertisement

Reset to Factory
Master Code reset to Factory 「12345」
Insert the jumper RES1
Insert the jumper to 2-3 position
Remove all stored information
Insert the jumper RES1
Factory 「12345」
information
Return Insert the jumper to 2-3 position.
Note:
If you only wish to reset the Master Code to the Factory default, remove the
jumper after exactly 5 audible beeps, otherwise all cards / codes will be deleted.

5. Wiring diagram:

Auxiliary Reader
(Data/CLK Format)
Contact door reed switch
This reed switch is used
to reset the re-locking time
to 0 second when the door is moved.
(Using N.O. contact in case of door closed,
changeover to N.C. When door is moved)
FAIL-SAFE
LOCKING DEVICE
Note:
DG-30 controller and auxiliary reader distance must not exceed 20 meters; the data will
not transmit beyond this. The suggested wire gauge is #22~26 AWG.
Using a Linear supply power recommended, to prevent power reduction at the card
reader.
The varistor or diode must be connected across the lock terminal (electromagnet...)
operated by the device. The vartistor controls the overload produced by the strike coil
(EMP).
Egresses switch should be N.O. type.
Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG30 Ver. A Publish:2004.08.26
1-2 position 5 audible beeps Reset successful
1-2 position 5 audible beeps
after 5 seconds 5 audible beeps
Auxiliary Reader
(Wiegand 26 or
34-bit Format)
Push Button
Power Supply
Master Code reset to
Remove all stored
+12V
GND
DATA
CLK
BUZZER
+5V
Page: 4/ 4
Return
Tamper
Switch
To follow the
precedent of
Group 1 contacts
1 2 3
Re-set of all
system parameter

Advertisement

loading