GEM DG-30 Operation User's Manual

DG-30 Digital Keypad / Proximity Entry system

1. Product Characteristic:

Allows up to 150 Proximity cards / tokens or PIN codes
Tamper Switch Included
Door Reed Switch Input for Anti-Trailing
Fully Programmable via keypad and master code
Extendable from keypad only to proximity controller
Supports 26 or 34-bit Wiegand auxiliary reader
Logical memory to prevent duplication
Non-Volatile Memory
Invalid PIN Lock-out

2. Specifications:

Operating Voltage: 12 Vdc
Current Draw:
Input: request-to-exit, time out reed switch contact, auxiliary reader
Relays Electric Current: 2A MAX @30Vdc ；0.4A @ 120Vac
Memory Volume: 150 PIN codes or 100 Proximity cards/tokens and 50 PIN codes
Format: 26 or 34-bit Wiegand hexadecimal.
Relay 1 is controlled by 001~100 user slots（Cards or PIN codes）
Relay 2 is controlled by 101~150 user slots（PIN codes）
PIN codes: 5 digit codes only
Case Material: ABS （UL94V0）
Operating Temperature: -20~+70℃
Ambient Humidity: 5~95% relative humidity non-condensing
Visual Signals:
Red: Power on
Green: Relay activated
Tri-color LED:
Yellow: Program Mode
Red: The slot is registered、Lock-out
Green: This slot may register the card or PIN codes.
Factory Master Code: 12345
Invalid PIN Lock-out: The system will shut down for 60 seconds while 32 codes of
incorrectly Master Codes enrolled or PIN codes attempted.
EPROM: Non-volatile memory, System will retain all programs and codes after a total
loss of power.
Output: Dual relay, N.O./N.C./Com. Output (free voltage contact) 、Tamper switch
Relay Activation Time: （＊10、＊20）
Strike Time: 1~99 seconds（adjustable）
Strike mode: Access Timer or Latch
Color: Dark gray/ Beige White
Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG30 Ver. A Publish:2004.08.26
Operation User's Manual
60mA Max @12VDC
Page: 1/ 4