GEM DG-15 Series Operation User's Manual

DG-15 series Digital Keypad Entry system

1. Specifications:

Operating Voltage: 12 Vdc
Current Draw: Average 15mA, Peak 100mA @ 12Vdc
Input: request-to-exit, time out reed switch contact
Output: Dual relays, N.O./N.C./Com. Output (free voltage
contact)
Relays Electric Current: 2A MAX @30Vdc ；0.4A @
120Vac
Relay Activation Time:
Relay 1 time delay setting code「＊30」、Relay 2
setting code「＊31」
Strike Time: 1~99 seconds（adjustable）
Strike mode: Access Timer or Latch
Memory Volume: 20+1 PIN codes
Relay 1 is controlled by ＊01~＊20 user slots
Relay 2 is controlled by ＊21 user slots
Operating Temperature: -20~+70℃
Ambient Humidity: 5~95% relative humidity non-condensing
Factory Master Code: 12345
Invalid PIN Lock-out: The system will shut down for 60 seconds while 30 codes of
incorrectly Master Codes enrolled or PIN codes attempted（None beeper signal of
keypad activations）.
EPROM: Non-volatile memory, System will retain all programs and codes after a total
loss of power.
The indicator signal chart:
LED signal
Green LED Power on, stand-by
Red LED Relay 1 activated
Yellow LED Relay 2 activated
2. Operation Instruction:
Enter Program Mode:
1. Compose twice the master code (4 digit format press「1234」、5 digit format press
「12345」) → 2 beeps → you are now in the "programming mode".
2. After 60 seconds if you have not entered any codes or data, the system will
automatically exit from the programming mode.
Exiting from the program mode:
1. Press「#」 to exit from the programming mode.
2. After 30 wrong codes attempts at the master code the lockout facility will operate.
Add PIN codes
Enter the Programming mode, Enter the slot position code 「＊01~＊20」→????? Input
5 digit （or 4 digit）PIN codes→ (beep) enrolled
Press 「#」 to exit from the programming mode, or program other operating.
Note 1:
The codes「0000」,「00000」,「1234」,「12345」or master code are not be
used for PIN code.
Note 2:
Relay 2 is controlled by ＊21 user slots
To Delete a User Code：
Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG15 Ver. C Publish:2008.11.12
Operation User's Manual
1 Beep
2 Beeps
3 Beeps
5 Beeps
Sound signal
Effective PIN codes、Any key pressed
Entering 、Exiting from the Program mode
Data computing error
Master Code reset to Factory （12345）
（repeat）
Page: 1/ 3