Changing The Blade - Porter-Cable 1410 Instruction Manual

K
Fig. 18
Fig. 20

CHANGING THE BLADE

CAUTION: Disconnect the machine from the power source.
1. Use the 2.5mm hex wrench (provided) to remove the three blade cover retaining screws (F) Fig. 16. Rotate
the blade cover to expose blade (see Fig. 18).
2. Press in on arbor lock (G) Fig. 17, and at the same time rotate blade (H) by hand until the arbor lock engages.
3. Use the 8mm hex wrench (provided) to remove (by turning counterclockwise) the arbor bolt (J) Fig. 18.
Remove flat washer (K), outer blade flange (L), and blade (M).
DO NOT REMOVE INNER BLADE FLANGE.
4. Make sure inside surfaces of both the inner and outer
blade flanges are clean.
5. Position new blade onto arbor with the teeth pointing down
at front (see Fig. 19). Install outer blade flange (L) with recessed
side facing the blade, flat washer (K) and arbor bolt (J). Turn
arbor bolt clockwise to tighten securely.
6. Reposition blade cover to the machine and secure with the
three screws removed in step 1.
CAUTION: Make sure the 2.5mm and the 8mm wrenches
are removed, and that the arbor lock is disengaged before
reconnecting machine to power source.
J
L
O
N
A B
9
Fig. 19
O
N
Fig. 21
Fig. 22