M8X1.25 Hex; M8X1.25X16Mm Carriage Head; Flat - Delta ShopMaster BS220LS Instruction Manual

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
STAND
1. Assemble stand as shown in Fig. 3, using parts
shown in Fig. 2. The braces, legs and feet are numbered
the same in both illustrations. Insert the M8x1.25x16mm
carriage head screws through legs and braces then
place the 3/8" flat washers on the screws and secure
with the M8x1.25 hex nuts. Only tighten nuts finger-tight
at this time. NOTE: The top lips of the side braces (2)
Fig. 3, must fit on top of the front and rear braces (3).
The top lips of the side braces (4) Fig. 3, must fit on top
of the front and rear braces (5).
2. Attach the four plastic feet (11) Fig. 3, to the bottom
of each leg (6).
BAND SAW
TO STAND
1. Fig. 4 illustrates the two through holes (A) and two
threaded holes (C) which will be used to secure the band
saw to the stand.
2. Place the band saw on top of stand and line up the
two threaded holes (C) Fig. 4, with the two holes (D) Fig.
5, on upper brace of stand.
ASSEMBLY
6
C
7
3
5
11
Fig. 3
Fig. 4
D
Fig. 5
2
4
A
D