Service; Replacement Parts - Delta 20-950 Instruction Manual

ANNUAL MAINTENANCE STEPS
To reduce the risk of injury, user must read tool instruction manual before operating product.
To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before
installing and removing accessories, before adjusting or changing set-ups or when making repairs. An accidental
start-up can cause injury.
FOLLOW THESE STEPS ANNUALLY to properly maintain the 20-950 Drill Press.
1. Remove the six button head cap screws attaching the upper pulley cover and remove the cover.
2. Lower the quill to the lowest point.
3. Remove the plastic cap (A) Fig. 46 over the spindle to expose sleeve (B).
4. Insert 5 cc or one teaspoon of bearing grease inside the sleeve (B).
5. Replace the plastic cap (A).
6. Hold the cap (A) with your finger as you slowly return the quill to its upper position.
7. Cycle the pinion (P) three times to remove any air trapped between the grease and the spindle.
8. Place 5 drops of machine oil in the center hole (C) of the center shaft.
9. Place the upper pulley cover back on and secure with the six screws.

REPLACEMENT PARTS

Use only identical replacement parts. For a parts list or to order parts, visit our website at www.deltaportercableservicenet.
com. You can also order parts from your nearest factory-owned branch, Authorized Warranty Service Center or by calling
End User Services at (800) 223-7278 to receive personalized support from one of our highly-trained representatives.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For information about Delta Machinery, its
factory-owned branches, or to locate an Authorized Warranty Service Center, visit our website at www.deltaportercable.
com or call our End User Services at (800) 223-7278. All repairs made by our service centers are fully guaranteed against
defective material and workmanship. We cannot guarantee repairs made or attempted by others. By calling this number
you can also find answers to most frequently asked questions 24 hours/day.
You can also write to us for information at Delta Machinery, PO Box 2468, Jackson, Tennessee 38302-2468 - Attention:
End User Services. Be sure to include all of the information shown on the nameplate of your tool (model number, type,
serial number, date code, etc.)
A
B
Fig. 46

SERVICE

18
C
P