Philips CD191 Quick Start Manual
Hide thumbs
Also See for CD191:
- User manual (40 pages) ,
- Quick start manual (6 pages) ,
- User manual (39 pages)
Related Manuals for Philips CD191
Summary of Contents for Philips CD191
-
Page 1: Quick Start Guide
Register your product and get support at www.philips.com/welcome CD191 CD196 Quick start guide Connect Get started Enjoy... -
Page 2: Important Safety Instruction
Important safety instruction Connect Connect the base station • Use only the power supply listed in the technical data. • Dispose of used batteries according to the instructions. (Refer • Do not allow the product to come into contact with liquids. to the user manual online) • Risk of explosion if battery is replaced by an incorrect type. -
Page 3: Get Started
Get started Configure your phone Charge your phone 1 The batteries are pre-installed in the handset. Pull the battery tape off from the battery door before charging. 2 When using your phone for the first time, you see a welcome Charge 8 hours message (country dependent). Place the handset on the base station to charge the handset. 3 Set the country and language if prompted. -
Page 4: Call Log
Enjoy Call Call log Record an announcement (for CD196 only) 1 Press • To make a call, press and dial the phone number. and select a record. • To answer a call, press when the phone rings. To make a call 1 Press MENU/OK >... -
Page 5: Technical Data
Input: 100-240V 50/60Hz 0.2A; Output: 6V 500mA Note • You can install a DSL (digital subscriber line) filter to prevent noise and caller ID problems caused by the DSL interference. • Hereby, WOOX Innovations declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. You can find the Declaration of Conformity on www.p4c.philips.com. -
Page 6: Frequently Asked Questions
European Directive 2002/96/EC. 2014 © WOOX Innovations Limited. All rights reserved. Philips and the Philips’ Shield Emblem are registered trademarks of QSG_CD191-196 Koninklijke Philips N.V. and are used 05 90_EN_V4.0...